User's Manual
CPE-O-R-WS User Manual
Runcom Technologies Ltd. 27
Status – the air connection status. Searching – looking for valid WiMAX frame from base station,
DL Synchronization – BTS found and the CPE is performing network entry protocols, Operation
– the CPE is in service.
IP Address – if DHCP presented: CPE wait to get IP from the network resources. If data is
presented – it is the IP address, mask, gateway that the xNOC supported. If STATIC and data – it
is the static configuration at the CPE
4.9.3 LAN Information
Valid in router mode and shows the LAN configuration
4.9.4 Traffic Statistic Information
This page shows the traffic which transferred over the WiMAX air interface.
Figure 20: Traffic Data Counters