Dimensions Guide

Suit for Two handle centerset lavatory faucet
IMPORTANT NOTICES: For easy installation, please read
all the instructions completely before beginning. Before
installing this product ,make sure that water line trash is
cleared to avoid blockage .
WARNING: Assembly by a professional plumber is a required.
Thank you for selecting this product!
NOTES: Cleaning Instructions
CAUTION: Maintenance
1.Replacement parts may be available at the store where you purchased your faucet .
2.Always turn off water and relieve pressure working before on your faucet.
1.To keep the faucet clean you should clean the faucet frequently.
2.Clean the faucet with clear water or mild ,then dry the faucet with soft cotton cloths.
3.Do not use any abrasive cleansers cloths ,or paper towel.
4.Do not use any acid or abrasive detergent.
1
3
Slide lift rod(2) as shown.
Thread lift rod into lift knob(1).
Put the rubber washer and
locking nut on, Wrench up
the locking nut to lock firm
the faucet on sink.
4
Connect the two fiexible hoses
to water supply valves.
Drill thee 1-1/8 holes on the
sink. Install the body into the
holes.
As shown, place the drain
stopper (10) into the drain
rod into the ball rod opening
through stopper hole and
threaded it.
Insert lift rod(2) through lift
rod strap(12) and secure with
set screw(11).Place the ball
rod(9) through one of the holes
on the lift rod strap.Secure it with
the spring clip(13).
1
2
10
2
12
9
You should clean all the dirts
from valve outlets. Turning off
the water supply valves. This
is usually found near the water
meter. If you are replacing an
existing faucet ,remove the
faucet from the sink and clean
the sink surface thoroughly
2
1
As shown, insert flange (3)
with washer (4) through sink
drain hole (5). Thread drain
body (6) in position with ball
rod (9) under from the opening
facing back, tighten metal
locknut (8) securely. thread
drain tailpiece (7) into drain
body.
Turn the left handle counter-
clockwise to get the hot water.
turn the right handle clockwise
to get the cold water.
8
9
11
13
2
3
4
5
6
7
Parts and services: in fo@runfinegroups .com