Quick Start Guide

Click for Philips Hue
P/N: FOH-DSxx
Included in package:
● 1 - Dual Rocker Switch
● 1 - Screwless faceplate
● 1 - Single Rocker insert
● 1 - Wire nut for bypassing wired switch
● 1 - Backplate for surface mounting
● 2 - ⅜” Backplate attachment screws
● 2 - ¾” Junction box mounting screws
● 2 - Command Strips ®
● 1 - Installation Guide
Overview
The Click for Philips Hue is a “Friends of Hue”
switch that offers press and hold dimming and
scene functions when connected to the Philips Hue
Bridge v2+. Once connected to the Bridge, Click for
Philips Hue may be configured with the Hue App or
Apple Home Kit.
No battery or external power is needed. The switch
transmits control signals powered by the kinetic
energy produced with the click of the button.
Click for Philips Hue works with either Dual Rocker
inserts for controlling multiple zones or scenes or a
single rocker insert to match standard switches.
Both options support press and hold dimming. Use
the Dual Rocker inserts when adding Click to the
Hue Bridge, then install the Single Rocker insert if
desired.
Specifications:
The light switch is compatible with standard
decorator style faceplates. A screwless faceplate is
included.
Mounting
Always follow local electrical codes when installing this device.
Installation should be performed by a qualified professional.
Add the switch to the Hue bridge before mounting.
See instructions on page 2.
After adding the switch to the Hue bridge,
optionally replace the Dual rocker inserts with the
included Single Rocker (see instructions on page
2). Adding Click to the Hue Bridge is not supported
with the single rocker insert.
Option A: Flush mount on a standard electrical
switch box using included ¾” junction box mounting
screws. If installing in place of an existing switch:
turn off power, remove the existing switch, exclude
any ground wires and join together all remaining
wires previously connected to the old switch using
the included wire nut. Cover with any faceplate that
has a Decora size opening. Restore power.
Option B: Surface mount backplate to a flat
surface using included Command Strips or with
screws (not included). If using Command Strips,
make pull tabs accessible from center of backplate.
After the backplate is mounted, attach switch to
backplate using included ⅜” backplate attachment
screws. Snap on screwless faceplate.
AHD0643E 1