Installation Guide

Click for Philips Hue
P/N: FOH-DSxx
Included in the package:
● 1 - Dual Rocker Switch
● 1 - Screwless faceplate
● 1 - Single Rocker insert
● 1 - Wire nut for bypassing wired switch
● 1 - Backplate for surface mounting
● 2 - ⅜” Backplate attachment screws
● 2 - ¾” Junction box mounting screws
● 2 - Command Strips ®
● 1 - Installation Guide
Requires: Philips Hue Bridge v2 or newer
Overview
The Click for Philips Hue is a “Friends of Hue”
switch that makes Hue lights family and guest
friendly. Turn lights on and off in a standard,
intuitive way and press and hold for dimming. Once
connected to the Bridge V2, Click for Hue may be
configured with the Hue App or Apple HomeKit. No
battery or external power is needed. Click for Hue
is powered by the kinetic energy produced with the
click of a button. Dual Rocker inserts offer 4
buttons for control or use the single rocker insert to
match standard switches.
Specifications:
Mounting
Always follow local electrical codes when installing this device.
Installation should be performed by a qualified professional.
Add the switch to the Hue Bridge V2 before
mounting. See instructions on page 2.
After adding the switch to the Hue bridge,
optionally replace the Dual rocker inserts with the
included Single Rocker (see instructions on page
2). Adding Click to the Hue Bridge is not supported
with the single rocker insert.
The light switch is compatible with standard
decorator style single or multi-gang faceplates. A
single gang faceplate is included.
Option A: Surface mount backplate to a flat
surface using included Command Strips or with
screws (not included). If using Command Strips,
make pull tabs accessible through center of
backplate. After the backplate is mounted, attach
switch to backplate using included ⅜” backplate
attachment screws. Snap on screwless faceplate.
Option B: Flush mount on a standard electrical
switch box using included ¾” junction box mounting
screws. If installing in place of an existing switch:
turn off the power, remove the existing switch,
exclude ground wires if present (usually bare wires
connected to green screw) and join together all
remaining wires previously connected to the old
switch using the included wire nut. Do Not connect
ground wires in wire nut. Cover with any faceplate
that has a Decora size opening. Restore power.
AHD0643F 1