Trim Installation Guide

Radiator Trims
n 2” Minimum Overlap Required
n 12” Standard Length
n Av
ailable for Radiators From
1 Tube to 10 Tubes High
n 2” Minimum Overlap Required
n 12” Standard Length
n Av
ailable for Radiators From
1 Tube to 10 Tubes High
n 2” Minimum Overlap Required
n 6”x 2” Standard
n Specify Left or Right End Cap
n Available for Radiators From
1 Tube to 10 Tubes High
n 2” Minimum Overlap Required
n 12”x 12” Standard
n Available for Radiators From
1 Tube to 10 Tubes High
n 2” Minimum Overlap Required
n 12”x 12” Standard
n Available for Radiators From
1 Tube to 10 Tubes High
n 90˚ Angle Standard
n Other Angles Possible
n PC-3 F
its Standard 3”
Gap
n PC-10 Fits Gaps Up to 10” Field
Cut to Fit
CENTER
TRIM
END TRIM
END CAP TRIM
INSIDE
CORNER TRIM
OUTSIDE
CORNER TRIM
VERTICAL PIPE TRIM
3"MIN
.
All horizontal trims cover the
piping from both a frontal and
top view.
Horizontal Trim
Vertical pipe trims are used to cover pipes from the floor to the
Omnipanel/Radiator
.
Runtal offers two sizes of vertical trim: the
PC-3 and the PC-10.The PC covers will also cover the straight
shut off v
alves
.
Vertical Pipe Trims
PC-3
A three inch trim
piece, color matched
to the finish of the
Omnipanel/Radiator.
PC-10
A ten inch trim piece,
color matched to the finish
of the Omnipanel/Radiator.
T
he PC-10 may be cut in
the field if a height
between three and ten
inches is desired.