R1000 Alternate Mounting Sheet

Alternate Mounting for Runtal Radiators
KR10
Floor
Post
Attachment Bolt &
Nut (by others)
The KR10 Floor Post is typically used to mount R or RF radiators. Also,
R2F and R3F radiators over 4 tubes tall must also be mounted on KR10
Floor Posts. The K11 (R) or K12 (RF, R2F, R3F) wall mounting brackets
supplied with the radiator are bolted to the floor post, using nuts and bolts
supplied by the installer. The K45 offset bolt screws into the radiator, and
rests against the floor post to level the radiator.
The 3” x 3” base has four mounting holes. The installer supplies the
appropriate mounting bolts to secure the KR10 base to the floor.
The KR10’s height is fixed to provide 3” clearance under the radiator,
unless otherwise specified.
KR20
Pedestal
The KR20 Pedestal is used to mount R2F or R3F radiators, up to four
tubes tall. Radiators over four tubes tall should not be mounted on
KR20 Pedestals, because they will be unstable. Mounting is
accomplished by setting the radiator down over the fingers of the KR20.
The bottom tubes of the radiator rest on the pedestal, while the fingers
protrude up through the fins to stabilize the radiator.
Option #48 (no wall mounting clips or straps) should be ordered for
radiators to be mounted on KR20 Pedestals. The 3” x 3” base has four
mounting holes. The installer supplies the appropriate mounting bolts to
secure the KR20 base to the floor.
The KR20’s height is fixed to provide 3” clearance under the radiator,
unless otherwise specified.
KR30
Cantilever
Bracket
The KR30 Cantilever Bracket is used to mount R2F or R3F radiators, up
to four tubes tall. Radiators over four tubes tall should not be
mounted on KR30 Brackets, because they will be unstable. Mounting
is accomplished by setting the radiator down over the fingers of the KR30.
The bottom tubes of the radiator rest on the flat of the KR30, while the
fingers protrude up through the fins to stabilize the radiator.
Option # 48 (no wall mounting clips or straps) should be ordered for
radiators to be mounted on KR20 Pedestals. The KR30 Bracket is
typically used to mount the R2F or R3F radiators from window mullions,
where pedestal mounting is not desired. The installer supplies the
appropriate mounting bolts to secure the KR30.
KR4
Pedestal
The KR4 Pedestal is used to floor mount the RS2 and custom R column
radiators. The pedestal is welded to the radiator’s tubes at the same
intervals as would be required for wall mounting brackets. The standard
clearance under the radiator is 4”, unless otherwise specified.
The pedestal base is 5-1/2” x 3-3/4”, and includes two mounting slots.
The installer supplies the appropriate mounting bolts to secure the KR4
Pedestals to the floor.