User's Manual

The
“CONTEMPORARY”
Wireless Hand
Remote Operation
7
NOTE
:
This bed may show minor intermittent performance because of typical RF interference.
This is normal in the operation of the bed, not a defect.
Wave Massage Adjustments (N)
• Activates both units to wave mode massage. NOTE: You must stop the massage in order to activate another
massage setting such as full body or another wave massage.
Full Body Massage (M)
• Press to activate both the head and foot massages at the same time.
Zero Gravity (G)
• This function allows your legs to be lifted to a position slightly higher than the chest. This allows blood to flow
back to the heart, reducing stress and fatigue.
Incline (E)
• Press to raise the head section to an ideal position for watching TV, reading or laptop use.
Lounge (H)
• Press & Release to lower your legs, Raise your head and relax in a lounge position.
Under Bed Light (O)
• Press the button to turn on or off the under bed light. (Button on back of Hand Wand)
Remote Features
• The “PRIVIA” Wireless Adjustable Bed uses a RF (Radio Frequency) hand control system.
• The buttons are backlit, when a button is pressed, to aid in the visibility of the remote in low light environments.
• It is not necessary to face the receiver to operate the remote control. Remote signal is best transmitted within
9 feet (3 meters) of the receiver.
Safety
• In the case that an overload of weight is placed on the head or foot mechanism, the control unit will automatically stop all
functions. The control unit will automatically resume all functions 30 seconds after excess weight is removed.
• Massage motors will automatically shut off after running continuously for 15 minutes. All massage functions will be
operational again after 5 minutes. Automatic Shut Off will occur after 15 minutes of continuous use.
• The input transformer voltage is AC120V 60HZ, the output voltage is DC24V 3A. In the case of a short-circuit, a fuse on the
transformer will blow to protect the electrical equipment (Fuse: 1A~1.5A.). Should this occur, you MUST seek professional
assistance to replace the fuse. Call Customer Care at: 1-877-826-8757
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device
is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and
void user’s authority to operate the device.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Continued
NOTE
:
I f the massage motors are operating and the “FLAT” button (F) is presses, the massage motors will stop
operating during the lowering of the bed frame. after 30 seconds, the massage motors will resume operation.
Wireless
Adjustable Bed