User manual

RUSH Pin 1 CW user manual

AC power

Read Safety information on page 4 before connecting the fixture

to AC mains power.

For protection from electric shock, the fixture must be grounded

(earthed). The power distribution circuit must be equipped with a

fuse or circuit breaker and ground-fault (earth-fault) protection.

Socket outlets or external power switches used to supply the

fixture with power must be located near the fixture and easily

accessible so that the fixtures can easily be disconnected from

power.

Do not insert or remove live connectors to apply or cut power, as

this may cause arcing at the terminals that will damage the

connectors.

Do not use an external dimming system to supply power to the

fixture, as this may cause damage to the fixture that is not

covered by the product warranty.

The fixture can be hard-wired to a building electrical installation if you want to

install it permanently, or a power plug (not supplied) that is suitable for the

local power outlets can be installed on the power cable.

The fixture has an auto-ranging power supply that accepts AC mains power at

100 – 240 V, 50/60 Hz. Do not apply AC mains power that is not within this

range.