55cm Under Counter Fridge Instruction Manual Model number: RHUCF55(B) For Customer Services & Spare Parts please call 0845 208 8750 Opening times: Monday - Friday 8am – 6pm & Saturday 9am – 1pm or visit us at www.productcareuk.
Contents Before using the appliance …………………………………………………………………… 3 Safety Instructions …………………………………………………………………… 3 Conformity Information …………………………………………………………………… 3 Before switching on …………………………………………………………………… 4 Unit Parts …………………………………………………………………… 4 Transportation & Handling …………………………………………………………………… 5 Positioning …………………………………………………………………… 5 Door reversal …………………………………………………………………… 6 Appliance Safety …………………………………………………………………… 7 Electrical Safety ……………………………………………………………………
Safety Instructions Before using the appliance Safety Instructions • This model contains R600a refrigerant (the coolant isobutane), naturals gas that, is very environmentally friendly but also combustible. When transporting and installing the unit care must be taken to ensure that none of the refrigeration circuit components become damaged. In the event of damage avoid any naked flames or any sources of ignition and ventilate the room in which the unit is placed for a few minutes.
Important information Before Switching On • Wait 3 hours before plugging in the appliance in to the mains supply to ensure optimum performance, this allows the refrigerant to settle. • There may be an odour when you first switch on the appliance, it will disappear when the appliance starts to cool.
Important information Transportation and Handing For safe lifting, tilt the appliance backwards by no more than 45 degrees, hold the base and rear corners of cabinet. Lift the refrigerator carefully. Never use the door handles for lifting. To move the refrigerator on a flat level surface, tilt it slightly backwards onto the two rear rollers and push backwards. This unit is heavy and could cause injury – ensure there is sufficient person power to move the appliance.
Door reversal Door Reversal You will need to tilt the fridge backward to access the lower hinge which holds screws. Do not tilt more than 45 degrees and do not lay the fridge flat on its side. For your own safety, a minimum of 2 people should lift or tilt this product. Reversing the door: 1. Remove the two screws from the right hand bottom hinge, either with a Phillips head screwdriver or a spanner. 2. Support the door and gently remove the hinge. 3. Remove the door and place it on a cushioned surface. 4.
Appliance safety Appliance Safety This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Installation Installation After installation, do not switch the power to the refrigerator on for at least 3 hours – the unit needs to stand. The unit should be kept away from direct sunlight. If the appliance is located on carpet, damage may be caused to the carpet due to heat being emitted from the unit. Remove all transport tapes and foam protection pieces . Clean the interior of the refrigerator with a cloth dampened in lukewarm soap and water. Wipe with clear water and wipe dry.
How to use There should always be sufficient space between items of food in your refrigerator to ensure the cold air is able to circulate around the unit. Placing too much food into the refrigerator will increase energy costs and lower efficiency. Food stored in the refrigerator should be stored in sealed packets to prevent food becoming dry and to prolong the life of the food. Hot food should be fully cooled before placing in the refrigerator to prevent the refrigerator temperature from rising.
Cleaning and maintenance Replacing the bulb Unplug the appliance from the mains. Locate the lamp cover which is on the rear of the temperature control panel in the top right hand side of the refrigeration compartment. Using a Phillips head screwdriver remove the screw at the far end of the light cover and slide the cover off. Replace the bulb with a new one, maximum 15W. Put the lamp cover back on and screw in place. Check the temperature control knob has not been accidentally altered.
Cleaning and maintenance Internal Cleaning Disconnect the appliance from the power supply before cleaning. Do not pour water over the appliance. The refrigerator compartment should be cleaned periodically using a solution of bicarbonate of soda and lukewarm water. Clean the accessories separately with soap and water. Do not put them in the dishwasher. Do not use abrasive products, detergents or soaps. After washing, rinse with clean water and dry carefully.
Trouble shooting Trouble shooting If the appliance has stopped functioning completely: • Check the electrics in the location of the appliance. • Check the plug has been correctly connected to the socket. • Check the fuse in the plug. • Are there any faults with the socket? For this purpose, try the plug of your refrigerator by connecting it to a socket which you are sure is working. If your refrigerator does not get cold enough: • Turn the Thermostat control further towards 7.
Trouble shooting Bubbling and gurgling sound: • This noise is emitted as the coolant fluid flows through the pipes within the system. This is normal. Water flowing sound: • This is the normal sound of water flowing into the drain trough during the defrosting process. Heavy frost occurs on the back of the appliance Placing warm or humid food in the refrigerator can cause this problem. Ensure food is cooled first.
Important notes IMPORTANT NOTES: • In case of a sudden power loss or disconnecting and reconnecting of the plug to the electrical socket, the compressor protective thermal element will be opened as the pressure of the gas in the cooling system of your refrigerator has not yet been balanced. 4 or 5 minutes later, your refrigerator will start to operate; this is normal. • If you won't be using your refrigerator for a long time, disconnect the plug from the socket.
Connection to the mains supply WARNING- THIS APPLIANCE MUST BE EARTHED This appliance is designed to operate from a mains supply of AC230V ~ 50HZ. Check that the voltage marked on the product corresponds with your supply voltage. This product is fitted with a 13A plug complying with BS1363.
For Customer Services & Spare Parts please call 0845 208 8750 Opening times: Monday - Friday 9am – 5pm & Saturday 9am –1pm or visit us at www.productcareuk.com Revision 1 This symbol is known as the 'Crossed-out wheelie bin Symbol'. When this symbol is marked on a product/batteries, it means that the product/batteries should not be disposed of with your general household waste.