Under Counter Larder Fridge Instruction Manual Model number(s): RHUCLF55-H (B-H) (SS-H) For Customer Services & Spare Parts please call 0345 208 8750 or visit us at https://mda.russellhobbs.
Contents Safety Instructions ………………………………………. 3-5 Electrical Safety ………………………………………. 5 Transportation & Handling ………………………………………. 5 Installing & Switch on your Appliance ………………………………………. 6 Before Switching On ………………………………………. 7 Product Overview ………………………………………. 8 Unit & Spare Parts ………………………………………. 8 Usage ………………………………………. 9 Temperature Selection ………………………………………. 9 Door Reversal ………………………………………. 10-12 Replacing the Bulb ……………………………………….
Safety Instructions Important note: Please read this booklet before installing and switching on this appliance. The manufacturer assumes no responsibility for incorrect installation and usage as described in this booklet. Warning: When positioning the appliance, ensure the supply cord is not trapped or damaged. Warning: Do not locate multiple portable socket-outlets or portable power suppliers at the rear of the appliance. • This model uses natural refrigerant gas as part of its cooling system.
• Do not pull, twist or damage the power cable. • Do not plug-in or un-plug the appliance with wet hands to prevent electrical shock. • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children should not play with the appliance.
• One-, two- and three -star compartments (if they are presented in the appliance) are not suitable for the freezing of fresh food. • If the appliance is left empty for long periods, switch off, defrost, clean, dry and leave the door open to prevent mount developing within the appliance. Electrical Safety THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET • Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate.
Installing and Switching on Your Appliance • Operating voltage for your appliance is 220-240V at 50Hz. • Before plugging in the power supply, ensure that the voltage on the rating label corresponds to the working voltage of your electrical system in your home. • Insert the plug into an efficient Ground (Earth) connection. If the socket has no Ground (Earth) contact or the plug does not match, we suggest you call an authorised electrician for assistance.
Before Switching On • Before using your appliance, add a teaspoon of bicarbonate of soda to warm water and with a damp cloth wipe down all parts of the new appliance, then repeat the process with a clean damp cloth and dry. (ensure the appliance is not connected to the power when performing this task). • Remove all transport tapes and foam protection pieces . Clean the interior with a cloth dampened in lukewarm soap and water. Wipe with clean water and wipe dry.
Product Overview 1 2 8 3 4 5 6 1. 2. 3. 4. 7 Top cover Light & thermostat Adjustable shelf Drainage hole 5. 6. 7. 8. Non-adjustable shelf Crisper Adjustable feet Door racks Unit Parts & Spare Parts Before installation, check that all parts detailed in the product overview are present. If any parts are missing, please contact the Product Care Customer Service team on 0345 208 8750 or visit us at https://mda.russellhobbs.
Usage Allow to stand for a minimum of 3 hours before plugging in to the mains The temperature in the appliance is controlled by the temperature control knob located inside the fridge. Rotate the control knob left or right to regulate the temperature inside the fridge. On the temperature control, 0 is Off, 1 is the warmest setting and 7 is the coldest setting. Under normal conditions the temperature control should be set between 5 and 6.
Door Reversal You will need to tilt the appliance backward to access the lower hinge which holds screws. Do not tilt more than 45 degrees and do not lay the appliance flat on its side. For your own safety, a minimum of 2 people should lift or tilt this product. 1. Remove the 2 screw cap covered with a straight headed screw driver and remove 2 screws from the rear of the top cover with a Phillips head screwdriver. 2. Remove the top cover 3.
Door Reversal 4.Tilt the appliance carefully and remove the bottom hinge by removing the screws with a Phillips head screwdriver or a spanner. Also remove the adjustable feet from both sides. 5. Unscrew and remove the hinge pin from the bottom hinge. Flip the hinge and replace the hinge pin 6.Refit the bottom hinge to the opposite side and replace both adjustable feet.
Door Reversal 7. Place the door back on to the bottom hinge, and put the top hinge into the top of the door. Ensure that the door is aligned horizontally and vertically so that the seals are closed before tightening the top hinge to the appliance. 8. Refit the top cover and fix it with the 2 screws at the rear and refit the screw cap covers. Check that the door opens and shuts correctly after you have completed the door reversal process.
Replacing the Bulb The light is an energy efficient, long life LED. Therefore should not need replacing throughout the life of the product however if it does it has to be replaced by a qualified engineer. Please call the service team on 0345 208 8750. Energy Saving Advice • Do not install the appliance close to sources of heat, such as a cooker, dishwasher or radiator. • Locate the appliance in a cool well-ventilated room and make sure that the air vents are clear.
Food Storage Guidelines Refrigerator compartments Type of food Door or balconies of fridge Foods with natural preservatives, such as jams, compartment juices, drinks, condiments. Do not store perishable foods. Crisper drawer (salad Fruits, herbs and vegetables should be placed drawer) separately in the crisper bin. Do not store bananas, onions, potatoes, garlic in the refrigerator.
Maintenance & Cleaning Disconnect the appliance from the power supply before cleaning. Internal Cleaning • • • • • • • • • • • Turn off the power before cleaning, remove all food, shelves, drawers, etc. Do not pour water over the appliance. Check the door gasket regularly to make sure there are no debris. Clean the door gasket with mild soap and water.
Maintenance & Cleaning Disconnect the appliance from the power supply before cleaning. External Cleaning • Do not use hard brushes, clean steel balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline items clean refrigerator considering that this may damage the fridge surface and interior. Boiling water and benzene may deform or damage plastic parts.
Trouble shooting Problem Solution Check that the appliance is switched on. Check that there has not been a power cut. Check that the plug is not faulty. The fridge doesn't work Check that the fuse has not blown. Check that the voltage is correct for the appliance. Are there any faults with the socket? For this purpose, try the plug of your appliance by connecting it to a socket which you are sure is working. Check that there is not too much food in the appliance.
Trouble shooting Problem Solution Check all the food and drink that is in the fridge is in date and correctly packaged. If it isn’t then it should be removed immediately or repackaged. Smell/odour Check for spillages on each shelf, rack and drawer. You may need to remove the drawers to check that no spillages have settle underneath them. As spillages that have not been cleaned and have been left can cause smells and unwanted odours.
Connection to the Mains Supply WARNING- THIS APPLIANCE MUST BE EARTHED This appliance is designed to operate from a mains supply of AC220V - 240V; 50HZ. Check that the voltage marked on the product corresponds with your supply voltage.
Guarantee This product is guaranteed for 12 months from the date of the original purchase. If any defect arises due to faulty materials or workmanship you must contact Product Care with the original proof of purchase so a replacement or refund can be arranged. Refund or replacement is at the discretion of Product Care. The following conditions apply: • Product Care will require a valid proof of purchase at the point of replacement or refund.
Technical Specification Model number RHUCLF55-H (B-H) (SS-H) Rated Voltage 220V – 240V ~ 50Hz Capacity 130L External Dimensions(HxWxD) 850mm x 550mm x 580mm 21
Notes 22
Notes 23
For Customer Services & Spare Parts please call 0345 208 8750 or visit us at https://mda.russellhobbs.com This symbol is known as the 'Crossed-out wheelie bin Symbol'. When this symbol is marked on a product/batteries, it means that the product/batteries should not be disposed of with your general household waste. Only discard electrical/electronic/battery items in separate collection schemes, which cater for the recovery and recycling of materials contained within.
