Owner's Manual
8 Russound D850, D1650 Installation Manual
Connections for Bridge mode operation
BRIDGE MODE OPERATION
When the amplier is in Bridge mode operation, a single channel (the left)
is used to produce a high power mono output. Use one channel pair to
amplify the left channel by connecting the left audio signal to the L input of a
channel pair, setting the Stereo/Bridge switch to "Bridge" and connecting the
speaker as indicated below. Use a second channel pair for the right channel
by connecting the right audio signal to the L input of a second channel pair,
setting the Stereo/Bridge switch to "Bridge" and connecting the speaker as
indicated below.
RightLeft
Wiring Instructions - Bridge Mode
For Bridged amplier operation, turn o the power to the amplier and
connect an 8-ohm minimum load; follow the Bridge mode markings on the
back of the amplier: Connect the negative lead (-) of the speaker cable to
the R– terminal. Connect the positive lead (+) of the speaker cable to the L+
terminal. Set the Stereo/Bridge Mono switch to Bridge Mono, connect the
Line In feed from a source to the Left Line In connection and restore power
to the amplier.