Owner's Manual

11XZone70V Installation Manual
CONFIGURATION STREAMING SERVICE ACCOUNTS (OPTIONAL)
Note: Conguring accounts must be done before accessing any streaming
source which requires an account such as SiriusXM, Pandora, or Spotify. If using
more than one XStream Series device, dierent accounts may be entered for
each zone if desired.
Spotify® – Spotify account credentials are entered in the Spotify app on your
phone, tablet, or PC. No additional information needs to be entered on the
XZone70V. Note that the name that you congured under “Device Name” will
be the same name that appears in the Spotify Connect menu as an available
selection. This same name is also the name used when connecting via Apple
AirPlay.
Pandora®– Pandora account credentials are entered by using the MyRussound
App or a connected Russound XTS in-wall touchscreen. Choose “Pandora”
from the menu. If no account information has been entered, a login screen will
be displayed.
SiriusXM® – SiriusXM account credentials are entered by using the
MyRussound App or a connected Russound XTS in-wall touchscreen. Select
SiriusXM as the active audio source. If no account information has been
entered, a login screen will be displayed.
vTuner® – No account information is needed to access vTuner internet radio.
If you wish to associate an XZone70V with a vTuner account so that you can
share vTuner favorites across multiple devices, you can select “Get Access
Code” from the vTuner menu and enter that code at http://russound.vtuner.
com to associate the Streamer with your vTuner account.
TuneIn® – No account information is needed to access Tunein internet radio.
If you wish to associate a zone’s Streamer with a TuneIn account so that you
can share TuneIn favorites across multiple devices, you can select “Account
Association” from the zone’s TuneIn menu and enter that code in your account
settings page at http://www.tunein.com to associate the Streamer with your
TuneIn account.
DHCP Reset
A DHCP Reset can be performed using the factory reset button on the rear
panel of the XZone70V.
If your XZone70V cannot communicate on the network, you can reset its
DHCP connection by pressing and holding the Reset button on the rear of the
XZone70V for 3 seconds and then releasing it. This will restore the XZone70V to
a DHCP connection from a static IP connection.
Factory Reset
For a full factory reset, erasing all conguration settings, and re-locking the
XZone70V:
Press and hold the Reset button on the rear of the XZone70V for 10 seconds.
The Red Status LED will light and the XZone70V will reboot on its own.
Note: Performing a factory reset will restore the unit to its factory default
settings and the unit will require valid Russound Certied Installer credentials
in order to be unlocked and congured again. The factory reset will also delete
all personal information including service account settings and passwords.
There are four LED’s on the front panel of the XZone70V to assist with any troubleshooting.
This chart explains the operation of the LED’s:
TROUBLESHOOTING
System Status Yellow
LED
Green
LED
Red
LED
Blue
LED
Booting ON - - -
Ready - ON - -
Factory Reset - - ON -
Zone On - - - ON
Firmware Update - Blinking - -
Network Error Blinking - - -