Owner's Manual

13XZone70V Installation Manual
70/100V WIRING
Wiring a 70/100V high impedance amplier like the XZone70V is much simpler
than a traditional low impedance residential amplier. All connections are
made in parallel and a thinner gauge wire may be used for a high impedance
system than a low impedance system. Typical wiring would use a 16 or 18
gauge wire in a single run from the amplier to all possible speaker locations
(now or to be added in the future). A small loop can be left at each potential
speaker location.
Adding a speaker at each wire loop is easy (either now, or in the future,
allowing for easy system updates at any time). See diagram below.
From
Amplier
To Additional
Speaker