How to Guide
9Rev. 1
Russound Acclaim OutBack Loudspeaker Installation Manual
CONNECT TO AMPLIFIER / TROUBLESHOOTING
Connecting the amplier
1. Make sure the amplier is turned o.
2. Strip 1 to 2 inches (2.5 to 5 cm) o the end of each cable’s outer jacket.
Then strip just enough insulation o each wire to allow inserting the wires
fully into the amplier’s speaker terminals.
3. Twist the wire strands together so there are no strands separated from the
bundle.
4. Connect the wires to the speaker terminals, being sure to observe proper
polarity.
5. Check to make sure there are no stray strands of wire outside the terminals.
If there are, remove the wire, twist the strands together, and reconnect the
wire to the terminal.
Speaker care
These sealed construction speakers are made of durable materials that need
very little care. Occasionally wipe them with a soft, damp cloth. Do not use any
harsh detergents, chemical solvents, or abrasive materials on your speakers,
and do not spray water or other liquids into the grilles.
Troubleshooting Guide
Before returning your Russound speakers for service, try these simple
remedies rst.
No sound from either speaker:
• Incorrect source selected on receiver or preamplier.
• Mute button pressed on receiver.
• Wrong speaker output selected; many receivers have an "A" and "B" speaker
switch. Make sure it is in the correct position.
• In-wall volume control not turned up or wired incorrectly.
• If using a speaker selector, room/station not turned on or improperly
connected.
No sound from one speaker:
• Unsecured connection at either the speaker or amplier - double-check all
connections.
• Balance control turned all the way left or right - return it to center.
• Bad connecting cable between sound source and amplier - try a new
cable.
• Check for stray wire strands crossing the speaker terminals.
• Defective speaker - contact your Russound dealer or call Russound Tech
Support at 603.659.5170.
Mued sound from single point stereo speaker:
• Check polarity of speaker connections. One channel may be reversed.
Any other problems not listed, discuss with your dealer or call Russound.