Complement Series R10DT 10” Powered Subwoofer User’s Manual
IMPORTANT SAFEGUARDS “WARNING” TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. “CAUTION” TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
R10DT SUBWOOFER INTRODUCTION The Russound R10DT active subwoofer delivers the chest-thumping deep bass sound you want for a supersonic listening experience. Whether it’s the asteroids breaking apart in your favorite sci-fi movie or the in-yourface concert experience of a classic rock band performance, the R10DT keeps up its end of the deal in your home theater or audio system.
R10DT SUBWOOFER 1 2 3 4 5 6 7 8 9 4 1 Volume Level Adjustment: Increase or decrease the output level relative to the incoming signal. 2 Crossover: Provides active filtering of the incoming signal to allow only lower frequencies to be amplified. Adjustment range from 60Hz to 160Hz. 3 Power Auto, On and Off: Auto setting - amplifier turns on when audio is detected. On - amplifier is always on. Off - amplifier is off. 4 Phase Selection: The speaker Phase can be inverted 180 degrees.
R10DT SUBWOOFER CONNECTION OPTIONS Method B Note: Choose Method A, Method B or Method C connection option. DO NOT combine them; choose only one. This method provides better sound quality and is preferred over Method C. The preamp (variable line level) outputs from the receiver carry the full range of audio signal frequency and the R10DT will use the active crossover to filter out the mid- and high-range frequencies, those which the subwoofer is not designed to reproduce.
R10DT SUBWOOFER Method C (Most universal installation, least desirable sonically) This connection method allows the subwoofer to be used with virtually any audio system, but its audio output is not as clean as when line in or LFE signals are used as in Methods A and B. Connect speaker wire from the amplifier/receiver’s main Left and Right outputs to the speaker level input on the subwoofer.
R10DT SUBWOOFER SPECIFICATIONS Driver Complement and Enclosure: Voice Coil: Frequency Response: Amplification: THD+N: Crossover Frequency (-3dB): Audio Input: Power requirements: Dimensions: Weight: Front-firing 10” long throw woofer with dual ports 38mm dia. 28Hz to 160Hz +/- 3dB 120 watts continuous power into 4 ohm load 1.0% 60Hz @ Min., 160Hz @ Max. RCA Line Level and Speaker Level 120VAC 60Hz 1.25A Molded 2 terminal power cord 14.0" W x 16.3" D x 17" H (35.6 x 41.5 x 43.2 cm) 36.7lbs. (16.6kg.
Complement Series R10DT Powered Subwoofer User’s Manual 5 Forbes Rd. Newmarket, NH 03857, USA Tel 603.659.5170 • Fax 603.659.5388 e-mail: tech@russound.com 28-1172 01/04/05 Copyright © 2005 Russound® All rights reserved.
