Instruction manual

9
USER SECTION
Operation
If a zone key is lit red on the Basic Keypad,
press the key to deselect that zone before
you press the Talk key to send a page.
If a zone label appears in the display on
the Advanced Keypad, use the Next or
Previous key to select Page before you
press the Talk key.
All keypads indicate which zone is sending
a page, so you’ll know where it’s coming
from. The zone indication remains for 30
seconds after the Talk key is released to
simplify replying to the page.
The keypads in the receiving zones also
sound a double ping when the Talk key is
released. This lets you know the person
sending the page is done speaking and
you can reply to the page. Within 30 sec-
onds, simply press and hold the Talk key
and speak. Your reply will be heard only
in the zone that sent the page.
If you wish to reply to the page after the
30-second limit, you can use the intercom
function described below or a return page
to send your reply.
Intercom
Unlike a system-wide page, an intercom
session occurs only between two zones. To
use this feature, select a target zone on a
keypad. Press and hold the Talk key and
speak. Release the Talk key when you’re
done speaking.
On the Basic Keypad, press and release a
zone key to select the target zone (figure
6). The key lights up red to indicate the
zone is selected.
If the selected target zone is in Do Not
Disturb mode, the zone key and DND key
blink rapidly for 7 seconds.
On the Advanced Keypad, select a target
zone by using the Previous or Next key to
scroll through the list of available zones
until the display shows the zone you want
for the intercom session (figure 7).
If the selected zone is in Do Not Disturb
mode, the display alternately shows the
zone label and DND at 1-second intervals
and the DND key blinks rapidly for 7
seconds.
Fig. 6. Selecting a target zone on the Basic Keypad
Paging (cont’d)