Stereo Receiver User Manual

USER
INTERNAL SOURCE - AM/FM TUNER
SRC2 Remote Control
SRC2 Contr
ol of Tuner
Selecting the tuner
To select the tuner, push to toggle through
sources and choose the source number preassigned
to the AM/FM tuner (1), or use the UNO numeric
source inputs at the bottom of the SRC2.
Selecting the desired band
Push to toggle between AM/FM reception.
Selecting the desired frequency
Use the Channel and or and
for manual tuning. To move quickly through the chan-
nels, press and hold the button for more than 1.5
seconds. To directly select a station, enter the three-
or four-digit channel or frequency (1071 for 107.1,
etc.). European regions use five-digit station
frequencies.
Frequency Seek
The SEEK function is performed by pressing and
releasing the Select or or . To seek
higher frequency station press . Press for
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing or again con-
tinues the SEEK function. Once the highest frequency
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down.
Bank/Memory Presets
The AM/FM tuner has six banks of preset memory
settings, and each bank holds six presets for a total
of 36 possible presets.
Setting a Memory Preset
1. Select a bank - press and hold or
until the desired bank # (1-6) appears on the keypad.
2. Select a station - tune to the desired frequency
with ,
,
or .
3. Press and hold a # button (1-6) until M(#) SA(ved)
is displayed.
Recalling a Memory Preset
Press and to scroll through a loop dis-
play of all the configured memory presets for the cur-
rently selected bank.
Mute
Press the button to mute/unmute the tuner
audio output.
22