SS-4.2 / SS-6.
Introduction Thank you for purchasing a quality Russound product. The Russound SS-4.2 and SS-6.2 speaker selectors permit either four or six pair of speakers to be turned on and off through individual switches on the front panel. Multiple pairs may be engaged simultaneously if desired. When multiple pairs are engaged, impedance matching protection must be employed to protect the amplifier from damage. The SS-4.2 and SS-6.
Amplifier Requirements With internal impedance matching (switch set to “IN”) A 4-ohm stable amplifier is required. With external impedance matching volume controls (switch set to “BYPASS”) A 4 to 8-ohm stable amplifier may be used. (Note: overdriving your amplifier will potentially cause damage to the amplifier, selector, and volume controls, as overload protection is bypassed.) Amplifier Connection Note: use ONLY the amplifier’s A or Speaker 1 output. Do not use the B or Speaker 2 output.
Speakers Speaker wire L+ OUTPUT LR- R+ L+ OUTPUT LR- R+ ALTx Impedance Matching Volume Control IMPEDANCE BYPASS IN L+ INPUT LR- L+ R+ INPUT LR- R+ Speaker wire SS-6.2 IMPEDANCE 5 6 L+ L- R- R+ S P E A K E R S 3 4 L+ L- R- R+ S P E A K E R S 1 BYPASS IN 2 L+ L- R- R+ L+ LRAMPLIFIER NEWMARKET, NH, U.S.A. R+ Speaker wire 4 - 8-ohm Stable Amplifier SPEAKER 1 + - - L L + Conforms to UL 6500 Certified to CSA C22.
Speakers IMPEDANCE BYPASS IN Speaker wire SS-6.2 IMPEDANCE 5 6 L+ L- R- R+ S P E A K E R S 3 4 L+ L- R- R+ S P E A K E R S 1 BYPASS IN 2 L+ L- R- R+ L+ LRAMPLIFIER NEWMARKET, NH, U.S.A. R+ Speaker wire 4-ohm Stable Amplifier SPEAKER 1 + - - L L + Conforms to UL 6500 Certified to CSA C22.
Room Labels Choose the appropriate room label from the included label sheet and place it above the appropriate switch on the front panel of the SS-4.2/6.2. The labels are non-adhesive and slide into a groove machined into the aluminum front panel. This allows for easy re-assignment. Technical Specifications Power Handling: SS-4.2 200 W/CH peak, 100 W/CH RMS SS-6.2 200 W/CH peak, 70 W/CH RMS Frequency Response: +/- 0dB 20Hz to 20kHz Wire: 16 AWG to 12 AWG standard speaker wire Dimensions: SS-4.2 8.5"W X 1.
Russound sells products only through authorized Dealers and Distributors to ensure that customers obtain proper support and service. Any Russound product purchased from an unauthorized dealer or other source, including retailers, mail order sellers and online sellers will not be honored or serviced under existing Russound warranty policy. Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product.
5 Forbes Rd. Newmarket, NH 03857 ☎ 603.659.5170 • Fax 603.659.5388 e-mail: tech@russound.
