Use and Care Manual

TECHNICAL DATA AAC-06
AMERICAN ACCENTS
STONE SPRAYS
Form: GDH-349
Rev.: 043014
1
.DESCRIPTION AND USES .
Rust-Oleum
®
American Accents
®
Stone Sprays provide a unique
textured finish designed for use on wood, metal, ceramic, and
more.
PRODUCTS .
SKU (12 ounces) Description
238322 Tuscan Rock
223324 Mineral Brown
238325 Canyon Moss
7990830 Bleached Stone
7991830 Black Granite
7992830 Gray Stone
7994830 Sienna Stone
7995830 Pebble
.PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90ºF (10-32ºC)
and humidity is below 65% to ensure proper drying. Do not apply
to surfaces, when heated, exceed 200°F (93°C). Avoid spraying
in very windy and dusty conditions. Cover surrounding area to
protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by
washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow to
thoroughly dry. Remove loose paint and rust with a wire brush or
sandpaper. Lightly sand glossy surfaces to create a surface
profile.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control lead
exposure. Clean up carefully with a HEPA vacuum and a wet
mop. Before you start, find out how to protect yourself and your
family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
.PRODUCT APPLICATION .
PRIMING
Use of Rust-Oleum American Accents 7980 Aerosol Primer
promotes adhesion and enhances hiding and is especially
recommended for bare wood and metal. For best results, apply a
base coat of a color that blends well with the stone finish.
APPLICATION
Shake can vigorously for one minute after the mixing ball begins
to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN.
Contact Rust-Oleum. Shake often during use. Hold can upright
10-16” from surface and spray in a steady back-and-forth motion,
slightly overlapping each stroke. Keep the can the same
distance from the surface. Keep the can in motion while spraying.
Apply two or more light coats a few minutes apart to avoid drips
and runs. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 7F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to touch
in 15 minutes, dries to handle in 30 minutes and is fully dry in 24
hours. Recoat at anytime.
CLEAN-UP
When finished spraying, clear spray by turning can upside down
and depressing spray button for 3-5 seconds (some paint will be
sprayed out, so be careful to not inadvertently spray yourself or
other objects). Clean-up wet paint with xylene or mineral spirits.
Properly discard empty container. Do not burn or place in home
trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent
such as mineral spirits. Do not insert any object into can valve
opening.

Summary of content (2 pages)