MSDS

Date Printed: 5/7/2015
P308+P313 IF exposed or concerned: Get medical advice/attention.
P314 Get medical advice/attention if you feel unwell.
P302+P350 IF ON SKIN: Gently wash with plenty of soap and water.
P330 Rinse mouth.
P301+P312 IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell.
3. Composition/Information On Ingredients
HAZARDOUS SUBSTANCES
Chemical Name CAS-No. Wt.%
Range
GHS Symbols
GHS Statements
Propane
10-25
74-98-6
Toluene
10-25
GHS02-GHS07-
GHS08
H225-302-332-361-336-373-315
108-88-3
Hydrotreated Light Distillate
10-25
GHS06
H331
64742-47-8
n-Butane
2.5-10
106-97-8
Mineral Spirits
2.5-10
GHS06-GHS08
H331-372
64742-88-7
Aluminum Flake
2.5-10
GHS02
H228-261
7429-90-5
Xylene (mixed isomers)
2.5-10
GHS02-GHS07
H226-312-332-315
1330-20-7
Stoddard Solvent
1.0-2.5
GHS02-GHS08
H224-340-350-372
8052-41-3
Ethylbenzene
1.0-2.5
GHS02-GHS07
H225-332
100-41-4
The text for GHS Hazard Statements shown above (if any) is given in the "16. Other Information" section.
4. First-aid Measures
FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical
attention. Do NOT allow rubbing of eyes or keeping eyes closed.
FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.
FIRST AID - INHALATION: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is
experienced, get medical assistance immediately. Remove to fresh air. If not breathing, give artificial respiration. If breathing is
difficult, give oxygen. Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation.
FIRST AID - INGESTION: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the
lungs and cause severe lung damage. Get immediate medical attention. If swallowed, get medical attention.
5. Fire-fighting Measures
EXTINGUISHING MEDIA:
Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS LESS THAN 20°F. EXTREMELY FLAMMABLE LIQUID AND
VAPOR!Water spray may be ineffective. Closed containers may explode when exposed to extreme heat. Vapors may form explosive
mixtures with air. Vapors can travel to a source of ignition and flash back. Keep containers tightly closed. Isolate from heat,
electrical equipment, sparks and open flame. Perforation of the pressurized container may cause bursting of the can. Closed
containers may explode when exposed to extreme heat due to buildup of steam. No unusual fire or explosion hazards noted.
SPECIAL FIREFIGHTING PROCEDURES: Evacuate area and fight fire from a safe distance. Full protective equipment including
self-contained breathing apparatus should be used. Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Use water spray to keep fire-exposed containers cool. Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Remove all sources of ignition, ventilate area and remove with inert absorbent and non-
sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do not incinerate closed containers. Isolate
the hazard area and deny entry to unnecessary and unprotected personnel. Ventilate area, isolate spilled material, and remove with
inert absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations.
7. Handling and Storage
Page 3 / 8