MSDS

248878 AUTORF LSPR 6PK CLEAR & BASE COAT REMOVER Page 2 of 5

with liver abnormalities, kidney, lung, spleen, eye and blood damage as well as reproductive disorders.

Effects in humans, due to chronic overexposure, have included liver, cardiac abnormalities and nervous

system damage.

Section 4 – First Aid Measures

First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding

eyelids open. Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.

First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or

persists.

First Aid - Inhalation: If you experience difficulty in breathing, leave the area to obtain fresh air. If

continued difficulty is experienced, get medical assistance immediately.

First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this

material can enter the lungs and cause severe lung damage. Get immediate medical attention.

Section 5 – Fire Fighting Measures

Flash Point

-156°F

Extinguishing Media: Film Forming Foam Carbon Dioxide Dry Chemical Dry Sand Water Fog

Unusual Fire And Explosion Hazards: Water spray may be ineffective. Closed containers may explode

when exposed to extreme heat. Vapors may form explosive mixtures with air. Vapors can travel to a

source of ignition and flash back. FLASH POINT IS LESS THAN 20 °. F. - EXTREMELY FLAMMABLE

LIQUID AND VAPOR! Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and

open flame. Perforation of the pressurized container may cause bursting of the can.

Special Firefighting Procedures: Evacuate area and fight fire from a safe distance.

Section 6 – Accidental Release Measures

Steps To Be Taken If Material Is Released Or Spilled: Contain spilled liquid with sand or earth. DO NOT

use combustible materials such as sawdust. Dispose of according to local, state (provincial) and federal

regulations. Do not incinerate closed containers. Remove all sources of ignition, ventilate area and

remove with inert absorbent and non-sparking tools.

Section 7 – Handling and Storage

Handling: Wash thoroughly after handling. Follow all MSDS/label precautions even after container is

emptied because it may retain product residues. Avoid breathing vapor or mist. Use only in a well-

ventilated area. Wash hands before eating.

Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame.

Do not store above 120 ° F. Store large quantities in buildings designed and protected for storage of

NFPA Class I flammable liquids. Contents under pressure. Do not expose to heat or store above 120 ° F.