Use and Care Manual

TECHNICAL DATA PCG-09
PEEL COAT
®
BLASTED METAL
Form: GDH-1227
Rev.: 111716
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Peel Coat is a peelable rubber coating designed
for customizing various vehicle parts such as wheels, rims,
hoods and more. This premium formula is easy to peel, safe to
wash and can be applied to metal, plastic, chrome, glass and
other surfaces. This all-weather coating also protects against rust
and road debris. Peel Coat is a temporary coating with a service
life of 6 months.
.PRODUCTS .
SKU Description
311255 Blasted Metal Gold
311256 Blasted Metal Steel
311257 Blasted Metal Copper
312253 Blasted Metal Black Tungsten
316994 Blasted Metal Black Tungsten
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 65% to ensure proper drying.
Do not apply to galvanized metal. Avoid spraying in very
windy and dusty conditions. Cover surrounding area to
protect from spray mist.
PRIMING
Priming is not required or recommended.
SURFACE PREPARATION
Wash the surface with a commercial detergent or soap
and water prior to the application. Rinse with fresh water
and dry with a clean cloth.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 8-12" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Apply 4 or more light coats to build
desired coating thickness, followed by one or more
medium coat(s) to achieve a smooth final film. Note:
Target 50% coverage on the first coat. Allow the coating to
dry for about 5 minutes between coats. More coats will
result in a thicker coating which is easier to remove when
desired. Allow the coating to cure for 24 hours before
washing. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 20 minutes and can be handled in 1
hour.
REMOVAL
The film can be peeled off once the coating has fully cured. This
coating has been formulated for temporary use and is
recommended to be removed within 6 months or less. A
microfiber cloth or mineral spirits may assist in the removal of
coating in intricate areas.
CLEAN-UP
When finished spraying, clear the spray valve by turning
can upside down and pushing the button for 5 seconds.
Allow wet paint to dry and once dry, peel away or clean up
wet paint with mineral spirits. Properly discard empty
container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.