Use and Care Manual

ManualsBrandsRust-Oleum Concrete Stain ManualsPaint15 oz. Sienna Spray Paint (6-Pack)

STAIN

TECHNICAL DATA CST-02

CONCRETE STAIN SPRAYS

Form: CS1748

Rev.: 040914

DESCRIPTION AND USES .

Rust-Oleum

Concrete Stain is a penetrating water-based stain

designed for use on bare interior and exterior concrete and

masonry surfaces. This convenient spray is ideal for use on

small statuary, for adding accent colors to larger projects or for

touch up of previously stained projects. Application works best on

bare interior and exterior concrete and masonry surfaces.

Concrete Stain Sprays features a comfort tip with a wider finger

pad to reduce fatigue caused by continuous spraying and an

any-angle tip which allows you to spray at any angle.

.PRODUCTS .

SKU Description

247129 Burnt Brick

247161 Sienna

247162 Earth Brown

247163 Limestone

247166 Gloss Clear

247167 Matte Clear

..PRODUCT APPLICATION .

SURFACE PREPARATION

Proper surface preparation is critical to performance. Allow

new concrete to cure for a minimum of 28 days prior to

coating. Before coating bare concrete surfaces, remove

grease, oil, salt and other contaminants with a heavy duty

degreaser. Follow label instructions carefully. To promote

maximum adhesion, concrete should be etched with a

concrete etching solution. Follow label instructions

carefully.

APPLICATION

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Shake often during

use. Hold can upright 10-12” from surface and spray in a

circular or figure eight pattern. Apply the basecoat evenly

(100% coverage)and allow to dry approximately 1 hour

before applying accent color(s). Keep the can the same

distance from the surface. Keep the can in motion while

spraying. If desired, apply accent color(s) over the

basecoat to provide the desired level of contrast. Allow to

air dry a minimum of 1 hour before sealing. Do not use

near open flame.

..PRODUCT APPLICATION (cont.)

DRY & RECOAT

Dry and recoat times are based on 70°F (21°C) and 50% relative

humidity. Allow more time at cooler temperatures. Dries to touch

in 1 hour and can be recoated in 1 hour.

CLEAN UP

Wipe off tip before storing. Clean-up wet paint with xylene

or mineral spirits. Properly discard empty container. Do

not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

Summary of content (2 pages)

PAGE 1
STAIN TECHNICAL DATA CST-02 CONCRETE STAIN SPRAYS DESCRIPTION AND USES ..PRODUCT APPLICATION (cont.) . Rust-Oleum® Concrete Stain is a penetrating water-based stain designed for use on bare interior and exterior concrete and masonry surfaces. This convenient spray is ideal for use on small statuary, for adding accent colors to larger projects or for touch up of previously stained projects. Application works best on bare interior and exterior concrete and masonry surfaces.
PAGE 2
TECHNICAL DATA CONCRETE STAIN SPRAYS PHYSICAL PROPERTIES . Concrete Stain Sprays Resin Type Water-based Acrylic Pigment Type Varies with Color Solvents Water, Glycol Ethers MIR 1.5 Max Fill Weight 15 ounces Recommended Dry Film Thickness (DFT) per Coat 1.0-2.0 mils Practical Coverage at Recommended DFT (assumes 15% material loss) Dry Times at 77°F (25°C) and 50% Relative Humidity 12-16 sq.ft./can (1.11-1.