Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
LOW VOC CONCRETE FLOOR PAINT
Rust-Oleum Corporation Form: GDH-357
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 050514
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
LOW VOC CONCRETE FLOOR PAINT
Resin Type
Acrylic Modified Polyurethane
Pigment Type
Titanium Dioxide
Solvents
Propylene Glycol, Dipropylene Glycol n-Butyl Ether, Water
Weight
Per Gallon
10.0-10.1 lbs.
Per Liter
1.26-1.27 kg
Solids
By Weight
45-46%
By Volume
35-36%
Volatile Organic Compounds
<50 g/l (0.42 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-1.5 mils
(25-37.5µ)
Wet Film to Achieve DFT
(Unthinned Material)
3.0-4.5 mils
(75- 112.5µ)
Theoretical Coverage at
1 mil DFT (25µ)
561-577 sq.ft./gal. (13.8-14.2 m
2
/l)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
300-450 sq.ft./gal. (7.4-11.1 m
2
/l)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Foot Traffic
24 hours
Vehicle Traffic
5 days
Shelf Life
5 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see MSDS
Calculated values are shown and may vary slightly from the actual manufactured material
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.