Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
BLACKTOP FILLER SEALER
Rust-Oleum Corporation Form: GDH-401
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 080414
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
BLACKTOP FILLER SEALER
Resin Type
Acrylic
Pigment Type
Carbon Black, Mineral Fibers
Solvents
Propylene Glycol, Water
Weight
Per Gallon
12.5 lbs.
Per Liter
1.50 kg
Solids
By Weight
65.5%
By Volume
49.0%
Volatile Organic Compounds
<100 g/l (0.83 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
Conditional with squeegee and surface condition
Wet Film to Achieve DFT
(Unthinned Material)
Conditional with squeegee and surface condition
Theoretical Coverage at
1 mil DFT (25µ)
786 sq.ft./gal.
(19.3 m
2
/l)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
Up to 350 sq.ft./pail (8.6 m
2
/l)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Walk Ready
1 hour
Drive Ready
4 hours
Shelf Life
3 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see MSDS
Calculated values are shown and may vary slightly from the actual manufactured material
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.