Use and Care Manual

TECHNICAL DATA
ROC-264
RUST-OLEUM HOME
®
COUNTERTOP COATING KITS
2
Form: ARJ-2551
Rev.: 021423
PRODUCT APPLICATION (cont.)
SYSTEM APPLICATION (cont.)
STEP 1: Apply Countertop Base Coat in 2’x2’ sections, and
maintain a wet edge while rolling. Do not let product puddle.
Only one coat is recommended.
*NOTE: For White, 2 coats are required. After coating the
countertop, wait 4 hours before applying second base coat
or applying any necessary touch-ups. Let touched-up areas
dry for 1-2 hours (dry to touch) and then top coat can be
applied.
OPTIONAL/MARBLE VEINING STEP: Once base coat is
completely dry, additional Rust-Oleum HOME
®
coatings,
such as the Gray Marble Veining Paint, can be applied to
create a designer look. Be sure to follow the on bottle
coating instructions and ensure the surface has thoroughly
dried and is dust-free before applying the top coat (Step 2).
STEP 2: Apply Rust-Oleum Home
®
Countertop Top Coat.
The Countertop Top Coat can be applied 4 hours after
initial base coat application. Do not thin. Stir thoroughly
prior to use. Apply when air (ambient) temperature is
50-90°F (10-32°C) and relative humidity is below 85%. Use
a high-quality bristle brush or edger to trim the perimeter
and hard-to-reach areas. Use a high-quality, 1/4” nap roller
cover to apply an even coat onto the surface. Apply in 2’x2’
sections, and maintain a wet edge while rolling. Do not let
product puddle. Only one coat is recommended. If a second
coat is desired for additional durability or uniformity, wait
until the first coat is dry to touch (1-2 hours) before
applying, but must apply within 24 hours. For vertical
application, apply Countertop Top Coat in two thin coats.
IMPORTANT: Rust-Oleum HOME
®
Countertop Base
Coat and Top Coat are required for the project.
PRODUCT APPLICATION (cont.)
DRY & TOPCOAT TIMES
For full system, allow 24 hours for light countertop use.
Allow 72 hours before replacing large or heavier items
(avoid dragging). Full cure is 7 days. Do not clean before 7
days.
CLEAN UP AND STORAGE
Wash tools and equipment with warm water and a mild
detergent. Dried product remove with lacquer/thinner.
Protect unused product from freezing.
LIMITATIONS
Not for use on exterior spaces. Not for use on interior
surfaces that are sealed with a superhydrophobic sealer.
Not food safe. Do not prepare or put food directly on
surface.
MAINTENANCE
Fully cured countertop may be cleaned with mild soap and
water or a general purpose cleaner such as Original Krud
Kutter Cleaner Degreaser after 7 days. Do not use an
abrasive cleaner.
USAGE
Surface Protection - As with most manufactured laminate
and countertop surfaces, this paint finish will remain durable
with proper use and care. Use a trivet or other protective
material underneath all hot cookware and heated objects.
Use cutting boards or other protective surfaces when
preparing food. Heavy pounding, knives or other sharp
utensils may scratch the surface. Do not allow water to pool
for extended periods, clean up hot grease and any spills
with a cloth or non-scratch abrasive pad.