Use and Care Manual

TECHNICAL DATA OKN-03
OKON W-1
™
WATER REPELLENT SEALER FOR DENSE CONCRETE AND MASONRY
Rust-Oleum Corporation Form: GDH-568
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 102016
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
Physical Properties
OKON W-1
Resin Type
Acrylic / Silane-Siloxane
Color
Colorless
Solvents
Water
Weight
Per Gallon
8.3 lbs.
Per Liter
1.0 kg
Solids
By Weight
5%
By Volume
4%
Volatile Organic Compounds
<75 g/l (0.63 lbs./gal.)
Application Parameters
50-100°F (10-38°C) and <85% Relative Humidity
Practical Coverage at Recommended
DFT (assumes 15% material loss)
[Square feet per Gallon]
Pre-Cast
Smooth
Brush-Blasted
Exposed
Aggregate
150 sq.ft./gal.
100 sq.ft./gal.
100 sq.ft./gal.
Stucco, Plaster or
EIFS
Smooth
Textured
Rough
250
150
100
Brick
Clay
Concrete
Glazed
200
150
Not recommended
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Recoat
3 hours
Foot Traffic
8 hours
Protect From Rain
24 hours
Protect From Dew
12 hours
Shelf Life
3 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.