Use and Care Manual

TECHNICAL DATA
PAINTER’S TOUCH
®
ULTRA COVER 2X ENAMEL SPRAYS
Form: GDH-503
Rev.: 011416
2
PRODUCT APPLICATION (cont.) .
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent or other suitable cleaning method. Rinse
thoroughly with fresh water and allow to thoroughly dry. All
surfaces must be dry at time of application. Remove loose
paint and rust with a wire brush or sandpaper. Lightly sand
glossy surfaces to create a surface profile.
WARNING! If you scrape, sand or remove old paint from
any surface, you may release lead paint dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE;
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by
contacting the National Lead Information Hotline at 1-800-
424-LEAD or log on to www.epa.gov/lead.
PRIMING
Use of a Painter’s Touch® primer provides excellent
adhesion and hiding and is especially recommended for
bare wood and metal. The following primers are
recommended:
249086 Red Primer
249088 Gray Primer
249846 Black Primer
249058 White Primer
PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-16" from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply two or more
light coats a few minutes apart to avoid drips and runs. Do
not use near open flame.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20 minutes, to handle in 1 hour, and is fully dry in
24 hours. Apply a second coat or Clear coat within 1 hour
or after 48 hours. Apply the clear coat in 2-3 light coats a
few minutes apart.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.