Use and Care Manual

TECHNICAL DATA
PT2X-02
PAINTER’S TOUCH
®
2X ULTRA COVER SATIN SPRAYS
2
Form: GDH-1269
Rev.: 013019
PRODUCT APPLICATION (cont.)
PRIMING
Use of Painter’s Touch 2X Ultra Cover
®
primer provides
superior adhesion and hiding and is especially
recommended for bare wood and metal. The following
primers are recommended
249058
White Primer
249086
Red Primer
249088
Gray Primer
249846
Flat Black Primer
APPLICATION
Shake can vigorously for one minute after mixing ball begins
to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN.
Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16" from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion
while spraying. Apply 2 or more light coats a few minutes
apart to avoid drips and runs. Do not use near open
flame.
PRODUCT APPLICATION (cont.)
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20 minutes, to handle in 1 hour, and is fully dry in
24 hours. Apply a second coat or clear coat within 1 hour or
after 48 hours. Apply clear in 2-3 light coats a few minutes
apart.
NOTE: On plastic maximum paint adhesion and durability is
achieved in 5-7 days.
CLEAN-UP
When finished spraying, wipe off tip before storing. Clean
up wet paint with xylene or mineral spirits. Properly discard
empty container. Do not burn or place in home trash
compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse it in a
solvent such as mineral spirits. Do not stick pin or other
object into the stem.