Use and Care Manual

TECHNICAL DATA
PAINTER’S TOUCH
®
PRIMERS
Rust-Oleum Corporation Form: CS2123
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 022013
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
AEROSOL BRUSH
Resin Type
Acrylic Modified Alkyd Water-based Acrylic
Pigment Type
Varies with Color Varies with Color
MIR
1.2 Max —
Fill Weight
12 ounces —
Solvents
Acetone, Toluene, Xylene Water and glycol ethers
Weight Per Gallon
NA 10.2-10.7 lbs.
Per Liter
NA 1.22- 1.28 kg
Solids By Weight
NA 51.5-55.2%
By Volume
NA 40.4-42.2%
Volatile Organic Compounds
— <160 g/l
(1.33 lbs./gal.)
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.5 mils
(37.5-62.5µ)
1.5-2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT
(unthinned material)
— 3.5-6.0 mils
(87.5-150µ)
Theoretical Coverage at 1
mil DFT (25µ)
—
220-385 sq. ft./gal.
(5.1-9.5 m
2
/l)
Practical Coverage at
Recommended DFT
(assumes 15% material loss)
10-12 sq. ft./can
(0.9-1.09 m
2
/l)
55-95 sq. ft./qt.
(5.0-8.8 m
2
/l)
Dry Times at
77°F (25°C)
and 50%
Relative
Humidity
Touch
20 minutes 30-60 minutes
Handle
1 hour 1-2 hours
Recoat
Within 1 hour or after 24 hours After 24 hours
Dry Heat Resistance
200ºF (93ºC) 200ºF (93ºC)
Shelf Life
5 years 5 years
Flash Point
-156°F (-104°C) >200°F (93°C)
Safety Information For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.