Use and Care Manual

ManualsBrandsRust-Oleum Professional ManualsPaint1-gal. Black Semi-Gloss Protective Enamel Paint (2-Pack)

TECHNICAL DATA

PROFESSIONAL DTM ALKYD ENAMEL GALLONS

Form: CS2288

Rev.: 032913

PRODUCT APPLICATION

PAINTING CONDITIONS

Apply only when air and surface temperatures are

between 32-90ºF (0-38ºC) and humidity is below 85% to

ensure proper drying. Do not apply to surfaces that, when

heated, exceed 200ºF (93ºC) or galvanized metal. Can be

used over most latex or oil paints. Professional DTM Alkyd

Enamels and Primers are not recommended for water

immersion.

PREPARATION

Clean surface with soap and water, rinse and let dry.

Remove loose paint and rust with a wire brush or

sandpaper. Lightly sand glossy surfaces. WARNING! If

you scrape, sand, or remove old paint, you my release

lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST

CAN CAUSE SERIOUS ILLNESS SUCH AS BRAIN

DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT

WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a

NIOSH-approved respirator to control lead exposure.

Clean up carefully with a HEPA vacuum and a wet mop.

Before you start, find out how to protect yourself and your

family by contacting the National Lead Information Hotline

at 1-800-424-LEAD or log on to www.epa.gov/lead.

APPLICATION

Mix thoroughly to ensure any settled pigment is re-

dispersed before using. Thin material, only if necessary,

with acetone. For brush or roller, thinning is not normally

required. For air spray, thin up to 1-1/2 to 2 pints per

gallon. Do not thin with gasoline, lacquer thinner,

turpentine, etc. For airless spray, thinning is not normally

required. Apply with a good quality brush, roller or spray

gun.

Brush: Use light, even strokes Excessive brushing

reduces film thickness and protection.

Roller: The rougher the surface, the longer the roller nap

should be. Cover approximately one square yard at a time.

Roll away from previously coated area and work back o it

for a uniform appearance. Use a brush on crevices and

sharp edges.

Spray Gun: Follow spray gun directions carefully. Always

keep the gun ten to twelve inches from the surface and in

motion while spraying.

CLEAN-UP

Clean brush, roller and other tools with mineral spirits.