Use and Care Manual

TECHNICAL DATA
PROFESSIONAL MARKING & STRIPING SPRAYS
Rust-Oleum Corporation Form: CS1446
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 082214
Vernon Hills, Illinois 60061 www.rustoleum.com/industrial
An RPM Company
PHYSICAL PROPERTIES .
MARKING
STRIPING
Resin Type
Vinyl Toluidine Modified Alkyd
Vinyl Toluene Modified Alkyd
Pigment Type
Varies with color
Varies with color
Solvents
Acetone, N-Butyl Acetate, Toluene,
VM&P Naphtha, Xylene
Acetone, Mineral Spirits, Toluene,
VM&P Naphtha, Xylene
MIR
1.1 Max
1.1 Max
Fill Weight
15 oz. (426 g)
18 oz. (510 g)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
300-350 linear feet (91-106 meters) at
1.5 inch wide (3.8 cm) (coverage is
dependent on surface porosity)
2 inch stripe: 400 feet
2 inch stripe: 300-400 feet (2593838)
4 inch stripe: 200 feet
4 inch stripe: 150-200 feet (2593838)
(coverage is dependent on surface
porosity)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Tack-free
<5 minutes
<10 minutes
Recoat
—
Anytime
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.