Manualshelf

Instructions / Assembly

ManualsBrandsRust-Oleum Restore ManualsPaint1 gal. Metallic Semi-Transparent Silver Slate Stain
1234
RESTORE Metallic Semi-Transparent Stain – Tips & Application
Instructions
Page 1 of 4
READ ALL INSTRUCTIONS BEFORE BEGINNING
For videos, information, and helpful tips on preparation, deck application, concrete application, and
maintenance; visit rustoleum.com/restore.
1. SURFACES
Wood: Restore Metallic Semi-Transparent Stain should only be applied on structurally sound wood surfaces.
NOT FOR USE ON: Composite decking, concrete, fiberglass, tile, and metal surfaces. These surfaces will not allow
for proper adhesion. Do not use on driveways, garages, or other areas with vehicular traffic.
2. NEW WOOD
New wood may be wet with chemicals or have mill glaze from the manufacturing process. New wood should age
for a minimum of 6 months before applying Restore Metallic Semi-Transparent Stain. The lumber must dry
completely before applying the product to prevent peeling of the coating. The surface must also be properly
cleaned and prepared using Restore Deck & Concrete Cleaner to remove all foreign material and mill glaze prior to
application. Follow the PREPARATION instructions to be sure the Restore Metallic Semi-Transparent Stain adheres
properly to the wood.
3. TINTING
Restore Metallic Semi-Transparent Stain is available in two pre-tinted colors, Blazing Bronze and Silver Slate. THIS
PRODUCT DOES NOT NEED TO BE TINTED AT THE STORE.
4. COVERAGE
• One 1-gallon can of Metallic Restore Semi-Transparent Stain will cover up to 200 square feet with one
coat
5. SURFACE PREPARATION
Stop, Watch, and Roll: For more information and helpful tips watch the Preparation with Restore Deck Stripper
video.
READ ALL INSTRUCTIONS THOROUGHLY PRIOR TO BEGINNING.
REGARDLESS OF AGE OR SURFACE CONDITION, FAILURE TO FOLLOW THIS PREPARATION METHOD WILL RESULT
IN POOR ADHESION AND POSSIBLE COATING FAILURE. NEW WOOD DECKS NEED TO WEATHER AT LEAST SIX
MONTHS BEFORE APPLICATION.
PREPARATION WITH RESTORE DECK STRIPPER
Step 1 – Remove existing Stain/Sealer:
Previously applied coatings need to be removed for two very important reasons; first stains do not adhere well to
one another and second the old finish will block the new finish from penetrating the wood. If the old stain or
sealant is peeling, it will pull your new coating up as well. The new topcoat will not lock down and seal the old
topcoat. Even if you have not recoated your deck in many years and it looks like there is no stain or sealant left on
the deck, you must complete this step. Previously applied stains and sealants may be present on the deck and are
not always visible and they will prevent the new topcoat from properly adhering to the wood.
Strip the surface using a deck brush and the Restore Deck Stripper. Apply the deck stripper to the deck and scrub it
into the wood with a deck brush. Let it sit for 15 minutes, then power wash it off completely. Follow all of the

Summary of content (4 pages)