Instructions / Assembly

ManualsBrandsRust-Oleum RockSolid ManualsPaint1 gal. Gunmetal Metallic Garage Floor Kit

RockSolid

Metallic

Garage Floor Coating

TURN A BORING, BLANK SPACE INTO A MODERN DAY CANVAS

Visit www.homedepot.com/rustoleum for

other great ideas, products and inspiration.

Shown with

RockSolid

Metallic Floor Coating Kit

Copper Pot

STEPS

1. PREPARE CONCRETE SURFACE: Scrub heavily-soiled areas with a heavy-duty degreaser and then etch entire

oor with concrete etch (included), rinse thoroughly & allow to dry completely.

2. BURST-SHAKE-POUR: Roll side A of Polycuramine pouch toward side B, burst and mix the two parts. Shake

well for 2-3 minutes. Cut one corner and pour contents into mixing bucket.

3. MIX IN METALLIC POWDER: Add metallic tint to bucket. Mix with paddle mixer and drill for 2-3 minutes until

thoroughly mixed.

4. APPLY COATING: Trim outer edges with a brush and then begin to apply the coating in 5’ x 5’ sections. Tip:

After rolling out each section, use the roller to put circular patterns in the coating (like applying wax to a car) to

ensure there are no bare spots. This will give the coating an opaque appearance once dry. See instructions for

working time of product after mixing.

5. Repeat the above steps for each additional pouch. Mix only one pouch at a time.

RockSolid Dry Time: Temperature and humidity may affect drying time. Do not walk on coating while it is still tacky. Surface

should be ready for foot trafc in 8-10 hours and vehicle trafc in 24-36 hours, depending upon temperature and humidity.

Always thoroughly review directions on package before using any product.

Completely transform your garage from a messy storage room into an inspiring functional space.

Optional

• Anti-skid additive

• Heavy-duty degreaser

• Concrete Patch and Repair Product

• Paddle mixer

• Drill

ITEMS

• RockSolid

Metallic Floor

Coating Kit-(Kit

contains: Concrete Etch,

3/8”nap Polyamide Roller,

Metallic tint, Polycuramine

burst pouch, instructions and

stir stick)

• 9” Roller frame

• Roller extension pole

• Stiff bristled broom brush

• 3” paint brush

• Mixing bucket

Summary of content (3 pages)

PAGE 1
RockSolid Metallic Garage Floor Coating ® TURN A BORING, BLANK SPACE INTO A MODERN DAY CANVAS Completely transform your garage from a messy storage room into an inspiring functional space.
PAGE 2
RockSolid® Metallic Floor Coating APPLY ROCKSOLID® OVER TILE TO GIVE IT A SPARKLING NEW LOOK Step 1: Deglaze entire tile surface using 60 to 80 grit sandpaper on a pole or orbital sander. Vacuum all sanding dust from surface using a shop vac. This step is very important. Step 2: Clean entire surface using Acetone or Denatured Alcohol. Rinse using water. i a mop and d clean l t Let L t Dry.
PAGE 3
RockSolid® Metallic Floor Coating A NEW LOOK FOR WOOD FLOORS WITH ROCKSOLID® Step 1: Sand entire wood surface using 80 grit sandpaper on a pole sander or orbital hand sander. Step 2: Remove sanding dust from surface using a tack cloth. cloth It is important that all dust is removed prior to applying the coating.