Use and Care Manual

TECHNICAL DATA
ROCKSOLID
®
MARBLE FLOOR COATING KIT
Rust-Oleum Corporation Form: GDH-1214
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 100416
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Resin Type
Proprietary Blend of Epoxy, Urethane and Polyurea
Pigment
Varies with color
Solvent
Benzyl Alcohol, 1-Chloro-4-(Trifluoromethyl) Benzene, Nonylphenol,
Neopentyl Glycol Diglycidyl Ether
Weight
Per Gallon
9.8 lbs.
Per Liter
1.18 kg
Solids By Volume
65.2%
Volatile Organic Compounds
<1 g/l
Practical Coverage
200-250 sq.ft./kit (4.9-6.2 m
2
/l)
(coverage rate can vary depending on texture and porosity of concrete)
Pot Life
45 minutes to 1 hour (depending on temperature and humidity)
Dry Times @ 70-80º F
(21-27°C) and 50%
Relative Humidity
†
Tack Free
8-10 hours
Dry Hard
12-16 hours
Drive Ready
24 hours depending on temperature
Shelf Life
24 months unopened factory delivered pouches
Safety Information
For additional information, see SDS
Calculated values are shown and may vary slightly from the actual manufactured material.
†
Dry times will be increase if temperatures are less than 55ºF (13ºC).
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.