MSDS

Page 5/13
Safety Data Sheet
according to 1907/2006/EC (REACH), 1272/2008/EC (CLP), and
OSHA GHS
Printing date 07.10.2014 Revision: 07.10.2014
Trade name: RockSolid Safe Etch
(Contd. of page 4)
39.4.1
SECTION 7: Handling and storage
·
7.1 Precautions for safe handling
Use only in well ventilated areas.
Prevent formation of aerosols.
·
Information about f ire - and explosion protection:
No special measures required.
·
7.2 Conditions for safe storage, including any incompatibilities
·
Storage:
·
Requirements to be met by storeroom s and receptacles:
Store in a cool location.
Avoid storage near extreme heat, ignition sources or open flame.
Unsuitable material for receptacle: aluminium.
·
Information about storage in one common storage facility:
Store away from foodstuffs.
Store away from oxidising agents.
Do not store together with alkalis (caustic solutions).
·
Further in formation about storage conditions:
Store in cool, dry conditions in well sealed receptacles.
Store receptacle in a well ventilated area.
Keep container tightly sealed.
·
7.3 Specific end use(s)
No further relevant information available.
SECTION 8: Exposure controls/personal protection
·
Additional info rmation about design of technical facilities:
No further data; see item 7.
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be
monitored at the workplace.
·
DNELs
No further relevant information available.
·
PNECs
No further relevant information available.
·
Additional Occupational Exposure Li mit Values for possible h a zards during proce ssi ng:
Limits for components as gases:
7647-01-0 hydrogen chloride
IOELV (EU) Short-term value: 15 mg/m³, 10 ppm
Long-term value: 8 mg/m³, 5 ppm
PEL (USA) Short-term value: C 7 mg/m³, C 5 ppm
REL (USA) Short-term value: C 7 mg/m³, C 5 ppm
TLV (USA) Short-term value: C 2,98 mg/m³, C 2 ppm
EL (Canada) Short-term value: C 2 ppm
·
Additional info rmation:
The lists valid during the making were used as basis.
(Contd. on page 6)