MSDS

Page 4/10
Safety Data Sheet
according to 1907/2006/EC (REACH), 1272/2008/EC (CLP), and
OSHA GHS
Printing date 29.09.2014 Revision: 29.09.2014
Trade name: Fortifying Sealer
(Contd. of page 3)
39.4.1
Wear fully protective suit.
·
Additional info rmation
No further relevant information available.
SECTION 6: Accidental release measures
·
6.1 Personal precautions, protective equipment an d emergency procedures
Use respiratory protective device against the effects of fumes/dust/aerosol.
Wear protective equipment. Keep unprotected persons away.
Ensure adequate ventilation
·
6.2 Environmental precautions:
Do not allow to enter sewers/ surface or ground water.
·
6.3 Methods and material f or containment and cleaning up:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Send for recovery or disposal in suitable receptacles.
·
6.4 Reference to other sections
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
SECTION 7: Handling and storage
·
7.1 Precautions for safe handling
Prevent formation of aerosols.
Use only in well ventilated areas.
Avoid splashes or spray in enclosed areas.
Keep receptacles tightly sealed.
·
Information about f ire - and explosion protection:
No special measures required.
·
7.2 Conditions for safe storage, including any incompatibilities
·
Storage:
·
Requirements to be met by storeroom s and receptacles:
Unsuitable material for receptacle: glass or ceramic.
Unsuitable material for receptacle: aluminium.
Avoid storage near extreme heat, ignition sources or open flame.
·
Information about storage in one common storage facility:
Store away from foodstuffs.
Do not store together with oxidising and acidic materials.
·
Further in formation about storage conditions:
Store in cool, dry conditions in well sealed receptacles.
Protect from frost.
·
7.3 Specific end use(s)
No further relevant information available.
SECTION 8: Exposure controls/personal protection
·
Additional info rmation about design of technical facilities:
No further data; see item 7.
(Contd. on page 5)