Use and Care Manual

ManualsBrandsRust-Oleum Specialty ManualsPaint11 oz. White Vinyl Spray Paint (6-Pack)

TECHNICAL DATA SPC-16

SPECIALTY

VINYL SPRAYS

Form: GDH-336

Rev.: 042914

.DESCRIPTION AND USES .

Rust-Oleum

Specialty Vinyl Sprays restore color on vinyl

and fabrics. This coating is ideal for car and boat seats,

dashboards, upholstery, luggage, furniture, sports

equipment and more. Specialty Vinyl Sprays feature and

advanced spray system that allows you to spray at any

angle, even upside down for those hard to reach areas. A

comfort spray tip with a wider finger pad to reduce fatigue

caused by continuous spraying.

.PRODUCTS .

SKU Description

1909830 Black

1911830 White

. PAINTING CONDITIONS .

Use outdoors or in a well ventilated area. Use when

temperature is between 50-90°F (10-32°C) and humidity is

below 85% to ensure proper drying. Do not apply to

surfaces, when heated, exceed 200°F (93°C). Do not

apply to galvanized steel. Avoid spraying in very windy

and dusty conditions. Cover surrounding area to protect

from spray mist.

. PRODUCT APPLICATION .

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical

contaminants by washing the surface with a commercial

detergent, or other suitable cleaning method. Rinse with

fresh water and allow to thoroughly dry.

.PRODUCT APPLICATION (cont.) .

APPLICATION

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Hold can upright 10-

16” from surface and spray in a steady back-and-forth

motion, slightly overlapping each stroke. Keep the can in

motion while spraying. Keep the can the same distance

from the surface. Apply two or more light coats a few

minutes apart to avoid drips and runs. Do not use near

open flame.

DRY & RECOAT

Dry and recoat times are based on 70ºF (21°C) and 50%

relative humidity. Allow more time at cooler temperatures.

Dries to the touch in 10 minutes, to handle in 1 hour and is

fully dry in 24 hours. Wait at least 6 hours before sitting or

using a painted object.

CLEAN-UP

Wipe off tip before storing. Clean-up wet paint with xylene

or mineral spirits. Properly discard empty container. Do

not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA SPC-16 SPECIALTY VINYL SPRAYS .DESCRIPTION AND USES . .PRODUCT APPLICATION (cont.) ® APPLICATION Rust-Oleum Specialty Vinyl Sprays restore color on vinyl and fabrics. This coating is ideal for car and boat seats, dashboards, upholstery, luggage, furniture, sports equipment and more. Specialty Vinyl Sprays feature and advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas.
PAGE 2
TECHNICAL DATA PEEL STOP – VINYL SPRAYS .PHYSICAL PROPERTIES . Physical Properties VINYL SPRAYS Resin Type Acrylic Lacquer Pigment Type Proprietary Solvents Acetone, Toluene, Xylene MIR 1.40 Max Fill Weight 11 ounces Practical Coverage at Recommended DFT (assumes 15% material loss) Dry Times at 70-80ºF (21-27ºC) and 50% Relative Humidity Approximately 7 sq.ft./can 2 (0.