Use and Care Manual

TECHNICAL DATA SPC-02
SPECIALTY
CAMOUFLAGE SPRAYS
Form: CS2434
Rev.: 042913
1
.DESCRIPTION AND USES .
A flat, non-reflective spray paint designed for use on
wood, metal, and other surfaces to disguise or break up
the outlines of items to blend in with different terrains.
These durable paints are suitable for outdoor use and
resist chipping, cracking, and peeling. Do not use on
galvanized surfaces.
.APPEARANCE .
Flat
.PRODUCTS .
FINISHES
1916830 Black
1917830 Khaki
1918830 Earth Brown
1919830 Deep Forest Green
1920830 Army Green
263653 Sand
.PAINTING CONDITIONS .
SURFACE PREPARATION
ALL SURFACES: Remove all dirt, grease, oil, salt and
chemical contaminants by washing the surface with a
commercial detergent, or other suitable cleaning method.
Mold and mildew must be cleaned with a chlorinated
cleaner or bleach solution. Rinse with fresh water and
allow to thoroughly dry.
STEEL: Scrape and wire brush or power tool clean to
remove loose rust, scale, and deteriorated coatings. Use
7569838 Red Primer for sound rusted or clean metal
before application of a finish coat.
PREVIOUSLY COATED: Previously coated surfaces must
be sound and in good condition. Smooth, hard, or glossy
surfaces should be scarified by sanding to create a
surface profile. . Removal of old paint by sanding, scraping
or other means may generate dust or fumes that contain
lead. LEAD IS TOXIC. Contact the U.S.EPA/Lead
Information Hotline at 1-800-424-LEAD pr log on to
www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
APPLICATION
Apply only when air and surface temperatures are
between 50-90°F (10-32°C) and the relative humidity is
below 85% to ensure proper drying. Use outdoors or in
areas with good ventilation. Avoid spraying in very windy
or dusty conditions. Cover surrounding area to protect
from overspray. Overspray can carry a significant distance.
Shake can vigorously for one minute after the mixing ball
begins to rattle. Shake often during use. Hold can upright
12-16" from surface and spray in a steady back-and-forth
motion, slightly overlapping each stroke. Keep the can the
same distance from the surface. Keep the can in motion
while spraying.
Apply a base coat of one color first. Then use leaves and
twigs as stencils and lay them on the surface to make a
random pattern. Then use three or more colors to paint
stripes and patterns over the leaves and twigs. Do not
use near open flame.
CLEAN-UP
Clean valve immediately after use by turning can upside
down and depressing spray button for 3-5 seconds. Clean
up wet paint with xylene or mineral spirits. Throw away
empty can in trash pick-up. Do not burn or place in home
trash compactor.
CLOGGING
If the value clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.