Use and Care Manual

ManualsBrandsRust-Oleum Specialty ManualsPaint11 oz. Fluorescent Green Marking Spray Paint (Case of 6)

TECHNICAL DATA SPC-12

SPECIALTY

MARKING SPRAYS

Form: GDH-331

Rev.: 042114

.DESCRIPTION AND USES .

Marking sprays marks the spot in a variety of bright, visible

colors. These sprays temporarily adhere to grass, gravel,

soil, lumber, concrete, and blacktop and withstand general

weathering. The convenient spray-thru cap makes these

sprays ideal for many outdoor uses such as marking

athletic fields, roadways, landscaping areas, work areas,

and more.

.PRODUCTS .

SKU Description

1985830 White

1987830 Fluorescent Orange

1988830 Fluorescent Pink

1989830 Fluorescent Green

1991830 Fluorescent Red

1997830 Bright Yellow

. PAINTING CONDITIONS .

Use outdoors or in a well ventilated area. Use when

temperature is between 50-90°F (10-32°C) and humidity is

below 65% to ensure proper drying. Do not apply to

surfaces, when heated, exceed 200°F (93°C). Avoid

spraying in very windy and dusty conditions. Cover

surrounding area to protect from spray mist.

. PRODUCT APPLICATION .

SURFACE PREPARATION

ALL SURFACES: Remove loose contaminants by

sweeping the surface before application of the coating.

.PRODUCT APPLICATION (cont.) .

APPLICATION

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Invert can and point

at ground or floor. Hold can 4-8" from surface to be

marked. Press tip sideways to spray paint. Spray using a

steady, even stroke to prevent build-up. Do not use near

open flame.

DRY & RECOAT

Dry and recoat times are based on 70ºF (21°C) and 50%

relative humidity. Allow more time at cooler temperatures.

Dries to the touch in 15 minutes and is fully dry in 8 hours.

May recoat at any time.

CLEAN-UP

Clean valve by spraying upright for 2-3 seconds after each

use. Clean up wet paint with xylene or mineral spirits.

Properly discard empty container. Do not burn or place in

home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA SPC-12 SPECIALTY MARKING SPRAYS .DESCRIPTION AND USES . .PRODUCT APPLICATION (cont.) APPLICATION Marking sprays marks the spot in a variety of bright, visible colors. These sprays temporarily adhere to grass, gravel, soil, lumber, concrete, and blacktop and withstand general weathering. The convenient spray-thru cap makes these sprays ideal for many outdoor uses such as marking athletic fields, roadways, landscaping areas, work areas, and more. .
PAGE 2
TECHNICAL DATA PEEL STOP – MARKING SPRAYS .PHYSICAL PROPERTIES . Physical Properties MARKING SPRAYS Acrylic Lacquer (Fluorescents) – Modified Alkyd (Non-fluorescents) Resin Type Pigment Type Varies with color Solvents Acetone, Aromatic Hydrocarbons, Toluene, Xylene MIR 1.20 Max Fill Weight 11 ounces Practical Coverage at Recommended DFT (assumes 15% material loss) Dry Times at 70-80ºF (21-27ºC) and 50% Relative Humidity Approximately 6-7 sq.ft./can 2 (0.56-0.