Use and Care Manual

TECHNICAL DATA SPC-23
SPECIALTY
APPLIANCE TOUCH-UP PAINT
Form: GDH-343
Rev.: 070816
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Specialty Appliance Touch-Up Paint is a
quick dry lacquer designed to provide a long-lasting, high
gloss finish on repairs to metal, porcelain, and appliances
such as stoves, refrigerators, washers, dryers and
dishwashers. This washable, moisture resistant finish is
designed for the exteriors of these surfaces. Do not use on
surfaces exposed to temperatures over 200°F (93°C) such
as stove tops. Not for use in sinks, tubs or other water
immersed surfaces.
.PRODUCTS .
SKU (0.6 ounces) _Description
203000 White
203001 Almond
203002 Biscuit
213174 Black
.PRODUCT APPLICATION .
PAINTING CONDITIONS
Use when air and surface temperature is between 50-90°F
(10-32°C) and humidity is below 85% to ensure proper
drying. Do not apply to surfaces, when heated, exceed
200°F (93°C).
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with soap and water.
Rinse with fresh water and allow to thoroughly dry.
Remove loose paint and rust with a wire brush or
sandpaper. Lightly sand glossy surfaces.
PRODUCT APPLICATION (CONT.)
SURFACE PRPERATION (cont.)
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you sand, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
APPLICATION
Shake bottle to mix product. Unscrew the cap brush and
apply Appliance Touch-Up Epoxy using even strokes. For
deep scratches or chips, apply multiple layers allowing 10
minutes between coats. For best results, allow to dry
overnight before use. Do not use near open flame.
DRY and RECOAT TIMES
Based on 70ºF (21ºC) and 50% relative humidity. Allow
more time at cooler temperatures. Dries to the touch in 10
minutes, to handle in 30 minutes and is fully dry in 24
hours. Allow to dry 10 minutes between coats.
CLEAN-UP
Clean up any excess product with lacquer thinner, rubbing
alcohol or acetone.