Manualshelf

Use and Care Manual

ManualsBrandsRust-Oleum Specialty ManualsPaint12 oz. Silver High Heat Spray Paint (6-Pack)
12
TECHNICAL DATA
PEEL STOP –
SPECIALTY HIGH HEAT
Rust-Oleum Corporation Form: CS2521
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 010714
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Sprays
Brush Goods
Low VOC
Resin Type
Modified Silicone
Acrylic Modified Alkyd
Acrylic Modified Alkyd
Pigment Type
Black Manganese Ferrite,
Chromite Black
Black Manganese Ferrite,
Chromite Black
Black Manganese Ferrite,
Chromite Black
Solvents
Acetone, Aromatic
Hydrocarbons
Aromatic Mineral Spirits
Aromatic Mineral Spirits
Weight
per Gallon
N/A
9.8 lbs./gal
10.9 lbs./gal
per Liter
N/A
1.17 kg
1.30 kg
Solids
by Weight
N/A
59.2%
67.9%
by Volume
N/A
38.1%
45.5%
Volatile Organic Compounds
N/A
475 g/l
(3.9 lbs./gal.)
420 g/l
(3.5 lbs./gal.)
Recommended Dry Film
Thickness
(DFT) per Coat
1.0-2.0 mils
(25-50µ)
1.0-2.0 mils
(25-50µ)
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
N/A
2.5-5.0 mils
(62.5-125µ)
2.0-4.5 mils
(50-112.5µ)
Theoretical Coverage at
1mil DFT (25µ)
N/A
611 sq.ft./gal.
(15.0 m
2
/l)
730 sq.ft./gal.
(17.9 m
2
/l)
Practical Coverage at
Recommended DFT
(assumes 15% material loss)
7-8 sq.ft./can
(0.63-0.72 m
2
/can)
65-130 sq.ft./quart
(1.6- 3.2 m
2
/l)
260-520 sq.ft./gal.
(6.4-12.8 m
2
/l)
310-620 sq.ft./gal.
(7.6-15.3 m
2
/l)
Touch
30 minutes
2-4 hours
2-4 hours
Handle
1-2 hours
5-9 hours
5-9 hours
Recoat
Within 1 hour or
after 48 hours
NA
NA
Full Cure
Allow paint to dry 1 hour
before heating
Allow paint to dry 24 hours
before heating
Allow paint to dry 24 hours
before heating
Dry Heat Resistance
1200°F (648°C)
1000°F (538°C)
1000°F (538°C)
Shelf Life
5 years
5 years
5 years
Flash Point
-156°F (-104°C)
104°F (40°C)
104°F (40°C)
Safety Information
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.