Use and Care Manual

TECHNICAL DATA SPC-01
SPECIALTY
APPLIANCE EPOXY SPRAYS
Form: GDH-324
Rev.: 042114
1
.DESCRIPTION AND USES .
Appliance epoxy is a hard, moisture resistant enamel that
is specifically formulated for indoor metal surfaces. It
provides a smooth, washable surface for refinishing the
exterior of appliances such as refrigerators, dishwashers,
laundry machines, dryers and other indoor metal
applications such as tables or cabinets. Interior use only.
.PRODUCTS .
SKU Description
210372 Biscuit
7881830 White
7882830 Almond
7886830 Black
7887830 Stainless Steel
.PAINTING CONDITIONS .
Use in a well ventilated area such as an open garage. Not
intended for continuous water immersion or for surfaces
that, when heated, exceed 200ºF (93ºC). Priming is not
recommended. Do not use on objects exposed to heat (ie.,
stovetops, oven interiors, etc.).
. PRODUCT APPLICATION .
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse with
fresh water and allow to thoroughly dry. Remove loose
paint and rust with wire brush or sandpaper. Lightly sand
glossy surfaces.
Removal of old paint by sanding, scraping or other means
may generate dust or fumes that contain lead. LEAD IS
TOXIC. Contact the U.S.EPA/Lead Information Hotline at
1-800-424- LEAD pr log on to www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
APPLICATION
Apply only when air and surface temperatures are
between 50-90°F (10-32°C) and the relative humidity is
below 85% to ensure proper drying. Avoid spraying in very
windy or dusty conditions. Cover surrounding area to
protect from overspray. Overspray can carry a significant
distance. Shake can vigorously for one minute after the
mixing ball begins to rattle. If mixing ball fails to rattle DO
NOT STRIKE CAN. Contact Rust-Oleum. Hold can upright
12-16" from surface and spray in a steady back and forth
motion, slightly overlapping each stroke. Keep the can the
same distance from the surface. Keep the can in motion
while spraying. Apply several light coats a few minutes
apart to avoid drips and runs. Do not use near open
flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF (21°C) and 50%
relative humidity. Dries tack free in 2-4 hours and can be
handled in 5-9 hours. Recoat within 30 minutes or after 1
week.
CLEAN-UP
Clean valve immediately after use by turning can upside
down and depressing spray button for 3-5 seconds (some
paint will be sprayed out, so be careful to not inadvertently
spray yourself or other objects). Clean up wet paint with
xylene or mineral spirits. Throw away empty can in trash
pick-up. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.