SDS

Date Printed: 5/22/2024
Skin Protection: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
Eye Protection: Use safety eyewear designed to protect against splash of liquids.
Other Protective Equipment: Refer to safety supervisor or industrial hygienist for further guidance regarding types of personal
protective equipment and their applications.
Hygienic Practices: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
Engineering Measures for Combustible Dust: No Information
9. Physical and Chemical Properties
Appearance:
Aerosolized Mist
Physical State:
Liquid
Odor:
Solvent Like N.E.
Odor Threshold:
Specific Gravity:
0.854
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Miscible
Partition Coefficient, n-octanol/
water:
N.D.
Decomposition Temp., °C:
N.D.
Boiling Range, °C:
-37 - 537
Explosive Limits, vol%:
1.0 - 13.0
Flammability:
Supports Combustion -96
Flash Point, °C:
Evaporation Rate:
Slower than Ether
Auto-Ignition Temp., °C:
N.D.
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
Conditions to Avoid: Avoid temperatures above 120°F (49°C). Avoid all possible sources of ignition. Avoid excess heat.
Incompatibility: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
Hazardous Decomposition: When heated to decomposition, it emits acrid smoke and irritating fumes. Contains solvents which may
form carbon monoxide, carbon dioxide, and formaldehyde.
Hazardous Polymerization: Will not occur under normal conditions.
Stability: This product is stable under normal storage conditions.
11. Toxicological Information
Effects of Overexposure - Eye Contact: Can cause severe eye irritation. Causes eye and skin irritation which may lead to dermatitis
with repeated exposures. Irritating, and may injure eye tissue if not removed promptly.
Effects of Overexposure - Skin Contact: Low hazard for usual industrial handling or commercial handling by trained personnel.
Effects of Overexposure - Inhalation: High gas, vapor, mist or dust concentrations may be harmful if inhaled. Avoid breathing fumes,
spray, vapors, or mist. Constituents of this product include crystalline silica dust which, if inhalable, may cause silicosis, a form of
progressive pulmonary fibrosis. Inhalable crystalline silica is listed by IARC as a group I carcinogen (lung) based on sufficient
evidence in occupationally exposed humans and sufficient evidence in animals. Crystalline silica is also listed by the NTP as a
known human carcinogen. Constituents may also contain asbestiform or non-asbestiform tremolite or other silicates as impurities,
and above de minimus exposure to these impurities in inhalable form may be carcinogenic or cause other serious lung problems.
Effects of Overexposure - Ingestion: Substance may be harmful if swallowed.
Effects of Overexposure - Chronic Hazards: High concentrations may lead to central nervous system effects (drowsiness, dizziness,
nausea, headaches, paralysis, and blurred vision) and/or damage. Reports have associated repeated and prolonged occupational
overexposure to solvents with permanent brain and nervous system damage. Overexposure to xylene in laboratory animals has been
associated with liver abnormalities, kidney, lung, spleen, eye and blood damage as well as reproductive disorders. Effects in
humans, due to chronic overexposure, have included liver, cardiac abnormalities and nervous system damage. Contains carbon
black. Chronic inflammation, lung fibrosis, and lung tumors have been observed in some rats experimentally exposed for long
periods of time to excessive concentrations of carbon black and several insoluble fine dust particles. Tumors have not been
observed in other animal species (i.e., mouse and hamster) under similar circumstances and study conditions. Epidemiological
studies of North American workers show no evidence of clinically significant adverse health effects due to occupational exposure to
carbon black.
Carbon black is listed as a Group 2B-"Possibly carcinogenic to humans" by IARC and is proposed to be listed as A4- "not classified
as a human carcinogen" by the American Conference of Governmental Industrial Hygienists. Significant exposure is not anticipated
during brush application or drying. Risk of overexposure depends on duration and level of exposure to dust from repeated sanding of
surfaces or spray mist and the actual concentration of carbon black in the formula. IARC lists Ethylbenzene as a possible human
carcinogen (group 2B). Contains Titanium Dioxide. Titanium Dioxide is listed as a Group 2B-"Possibly carcinogenic to humans" by
IARC. No significant exposure to Titanium Dioxide is thought to occur during the use of products in which Titanium Dioxide is bound
Stops Rust / Automotive Primer
Page 4 / 6