Use and Care Manual

ManualsBrandsRust-Oleum Stops Rust ManualsGeneral Purpose Spray Paint0.45 oz. Gloss Black Touch-Up Paint (6-Pack)

TECHNICAL DATA SRT-23

STOPS RUST

TOUCH UP PAINT

Form: GDH-27

Rev.: 040113

.DESCRIPTION AND USES .

Stops Rust

Touch Up Paint is designed for touch up repair for

indoor and outdoor metal furniture and accessories. Touch Up

Paint provides excellent rust resistance, chip resistance and color

retention when applied directly to metal. Touch Up Paint is

packaged with a convenient brush in the cap for application in

hard to reach areas. Not for use on galvanized steel.

.PRODUCTS .

.45 Ounces Description

215057 Gloss Black

215058 Gloss White

215059 Gloss Dark hunter Green

215110 Gloss Almond

..PRODUCT APPLICATION .

PAINTING CONDITIONS

Apply only when air and surface temperatures are

between 50-90°F (10-32°C) and humidity is below 85% to

ensure proper drying. Do not apply to surfaces that will

exceed 200°F (93°C). Do not use on galvanized steel.

SURFACE PREPARATION

ALL SURFACES: Remove all dirt, grease, oil, salt and

chemical contaminants by washing the surface with a

commercial detergent or other suitable cleaning method.

Rinse thoroughly with fresh water and allow to fully dry. All

surfaces must be dry at time of application.

STEEL: Scrape and wire brush or power tool clean to

remove loose rust, scale and deteriorated previous

coatings. Use 7769 Rusty Metal Primer or 225135 Touch

Up Rusty Metal Primer for sound rusted or clean metal

before application of a finish coat. 7780 White Clean

Primer is best for clean metal but may be used on sound

rusted metal as well.

PREVIOUSLY COATED: Previously coated surfaces must

be sound and in good condition. Smooth, hard, or glossy

finishes should be scarified by sanding to create a surface

profile. The Stops Rust

Enamels are compatible with

most coatings, but a test patch is suggested. WARNING! If

you scrape, sand or remove old paint from any surface,

you may release lead paint dust. LEAD IS TOXIC.

EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS

ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN

CHILDREN. PREGNANT WOMEN SHOULD ALSO

AVOID EXPOSURE. Wear a NIOSH approved respirator

to control lead exposure. Clean up carefully with a HEPA

vacuum and a wet mop. Before you start, find out how to

protect yourself and your family by contacting the National

Lead Information Hotline at 1-800-424-LEAD or log on to

www.epa.gov/lead.

..PRODUCT APPLICATION .

APPLICATION

Shake well before using. Apply Touch Up Paint with even

strokes. For deep scratches or chips, apply several coats

a few minutes apart. If necessary, recoat within 1 to 3

hours.

DRY & RECOAT TIMES

Dry and recoat times are based on 70°F (21°C) and 50%

relative humidity. Allow more time at cooler temperatures

and higher humidity. Dries to the touch in 2-4 hours, to

handle in 5-9 hours and can be recoated after 24 hours.

CLEAN-UP

Clean up drips and excess paint with mineral spirits or

xylene.

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA SRT-23 STOPS RUST® TOUCH UP PAINT .DESCRIPTION AND USES . ..PRODUCT APPLICATION ® Stops Rust Touch Up Paint is designed for touch up repair for indoor and outdoor metal furniture and accessories. Touch Up Paint provides excellent rust resistance, chip resistance and color retention when applied directly to metal. Touch Up Paint is packaged with a convenient brush in the cap for application in hard to reach areas. Not for use on galvanized steel. APPLICATION .
PAGE 2
TECHNICAL DATA STOPS RUST ENAMEL BRUSH PHYSICAL PROPERTIES . TOUCH UP PAINT Resin Type Oil modified Alkyd Pigment Type Varies with Color Solvents Weight Solids Mineral Spirits Per Gallon 7.4-7.6 lbs. Per Liter 0.9-0.91 kg By Weight 45.0-46.0% By Volume 37.0-37.2% Volatile Organic Compounds <485 g/l (4.04 lbs./gal.) Recommended Dry Film Thickness (DFT) Per Coat 1.5-2.5 mils (37.5-62.5 µ) Wet Film to Achieve DFT 4.0-6.5 mils (100-162.