Use and Care Manual

ManualsBrandsRust-Oleum Stops Rust ManualsPaint10.25 oz. Clear Rust Inhibitor Spray Paint

TECHNICAL DATA SRT-19

STOPS RUST

RUST INHIBITOR

Form: GDH-09

Rev.: 030613

.DESCRIPTION AND USES .

Rust-Oleum

Rust Inhibitor is a clear coating that protects

untreated, bare metal surfaces against moisture and other

corrosive elements. It is suitable for use on garden tools, bicycles,

metal sporting equipment, lawn equipment, iron railings and

other metal surfaces.

.PRODUCTS .

SKU (10.25 fl. oz.) Description

224284 Rust Inhibitor

..PRODUCT APPLICATION .

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical contaminants by

washing the surface with a commercial detergent, or other

suitable cleaning method. Rinse with fresh water and allow to

thoroughly dry. Remove all loose rust, scale, and previous

coatings with a wire brush, scraper, or Rust-Oleum

Rust

Stripper. WARNING! If you scrape, sand or remove old paint

from any surface, you may release lead paint dust. LEAD IS

TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS

ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN

CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID

EXPOSURE. Wear a NIOSH approved respirator to control lead

exposure. Clean up carefully with a HEPA vacuum and a wet

mop. Before you start, find out how to protect yourself and your

family by contacting the National Lead Information Hotline at 1-

800-424-LEAD or log on to www.epa.gov/lead.

..PRODUCT APPLICATION (cont.) .

PAINTING CONDITIONS

Use outdoors or in a well ventilated area such as an open

garage. Apply when temperature is between 50-90ºF (10-32ºC)

and humidity is below 85% to ensure efficient use of the product.

Do not apply to an area that, when heated, will exceed 120°F

(49°C). Avoid spraying in windy, dusty conditions. Cover

surrounding area to protect from spray mist.

APPLICATION

Shake can well before using and often during use. Hold can

upright 12-16” from the surface and apply a light, thin, even coat

to cover the surface. Additional coats provide increased

protection. Wipe off excess with a clean cloth if the coating is too

heavy. Re-apply every 1-2 years for indoor uses and every 6

months for outdoor uses.

PAINTING

If surfaces are to be painted in the future, remove Rust Inhibitor

from the surface with a solvent such as acetone or mineral spirits

prior to painting.

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA SRT-19 STOPS RUST RUST INHIBITOR .DESCRIPTION AND USES ..PRODUCT APPLICATION (cont.) . Rust-Oleum® Rust Inhibitor is a clear coating that protects untreated, bare metal surfaces against moisture and other corrosive elements. It is suitable for use on garden tools, bicycles, metal sporting equipment, lawn equipment, iron railings and other metal surfaces. .PRODUCTS Use outdoors or in a well ventilated area such as an open garage.
PAGE 2
TECHNICAL DATA STOPS RUST – RUST INHIBITOR PHYSICAL PROPERTIES . Physical Properties RUST INHIBITOR Composition Fill Weight VOC Shelf Life Flash Point Safety Information Petroleum Distillates 10.25 ounces 325 g/l 1 year from date of manufacture -156°F (-104°C) For additional information, see MSDS The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith.