Use and Care Manual

TECHNICAL DATA
CAB-11
RUST-OLEUM
®
CABINET TRANSFORMATIONS
®
BASICS CABINET & TRIM PAINT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙577∙8459
www.rustoleum.com
Form: ARJ-2605
Rev.: 021424
PHYSICAL PROPERTIES
CABINET TRANSFORMATIONS BASICS CABINET & TRIM PAINT
Resin Type/Composition
Water-Based Styrene Acrylic
Pigment Type
Varies by color
Solvents
Water, Glycol Ethers
Weight
Per Gallon
10.1-10.3 lbs.
Per Liter
1.2-1.3 kg
Solids
By Weight
52-53%
By Volume
40-42.5%
Volatile Organic Compounds
<50 g/l
Recommended Dry Film Thickness
(DFT) Per Coat
1-2 mils
Wet Film to Achieve DFT
(unthinned material)
2.5-5.0 mils
Practical Coverage at
Recommended DFT
(assumes 15% material loss)
Up to 100 sq. ft./quart
Up to 400 sq. ft./gal.
Coverage will vary depending on surface texture & porosity
Dry Times at 77°F
(25°C) and 50%
Relative Humidity
Touch
1 hour
Recoat
4 hours
Full Cure
7-10 Days
Flash Point
>200°F (93°C)
Shelf Life
3 years
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.