How to Guide

TECHNICAL DATA
1600 SYSTEM MULTI-PURPOSE ENAMEL AEROSOL
Rust-Oleum Corporation Form: GDH-11
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 021615
Vernon Hills, Illinois 60061 www.rustoleum.com/industrial
An RPM Company
.PRODUCT APPLICATION (cont.) .
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not burn
or place in trash compactor. Empty container can be recycled.
.PRODUCT APPLICATION (cont.) .
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.
. PHYSICAL PROPERTIES .
FLAT ENAMELS &
PRIMERS
GLOSS FINISHES
GALVANIZING*
Resin Type
Modified Alkyd
Modified Alkyd
Epoxy Ester
Pigment Type
Varies with color
Varies with color
1685830 contains 93% zinc in
the dry film
244305 contains greater than
65% zinc in the dry film (also
contains aluminum)
Solvents
Acetone, xylene, toluene (fluorescents contain hexane) and liquefied petroleum gas propellant
MIR
Maximum value of 1.2
Finishes: Max. value of 1.4
Metallics: Max. value of 1.9
Maximum value of 1.2
Fill Weight
12 oz.
Finishes: 12 oz.
Metallics: 11 oz.
14 oz.
Recommended Dry Film Thickness
Per Coat
1-2 mils
(25-50µ)
1-2 mils
(25-50µ)
1-2 mils
(25-50µ)
Practical Coverage at
Recommended DFT
†
12-15 sq.ft./can
(1.1-1.4 m
2
/can)
12-15 sq.ft./can
(1.1-1.4 m
2
/can)
12-15 sq.ft./can
(1.1-1.4 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
10 minutes
10 minutes
10-20 minutes
Handle
1 hour
1 hour
1-2 hours
Recoat
Within 1 hour or after 24
hours
Within 1 hour or after 24
hours
Within 1 hour or after 24
hours
Dry Heat Resistance
200°F (93°C)**
200°F (93°C)**
200°F (93°C)**
Shelf Life
5 years
5 years
5 years
Safety Information
For additional information, see MSDS
Calculated values are shown and may vary slightly from the actual manufactured material.
*Do not topcoat galvanizing compounds with an alkyd finish.
**Some discoloration may occur at temperatures above 150°F (65°C).
†
Actual coverage with complete hiding. Coverage may vary with color and substrate. The coverage rate can be optimized if applied
over the white or gray primer.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.