How to Guide

TECHNICAL DATA
S71 WATER-BASED EPOXY PRIMER
Rust-Oleum Corporation Form: GDH-985
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 102915
Vernon Hills, Illinois 60061 www.rustoleum.com/industrial
An RPM Company
PHYSICAL PROPERTIES .
Resin Type
Water-based Epoxy
Pigment Type
Titanium Dioxide
Solvents
Water
Weight*
Per Gallon
11.4 lbs.
Per Liter
1.4 kg
Solids*
By Weight
62%
By Volume
47%
Volatile Organic Compounds*
0.0 g/l
Recommended Dry Film
Thickness (DFT) Per Coat
2.0-3.0 mils
(50-75µ)
Wet Film to Achieve DFT
4.5-7.0 mils
(112.5-175µ)
Theoretical Coverage at 1 mil DFT
(25µ)
755 sq. ft./gal.
(18.5 m
2
/l)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
215-320 sq. ft./gal.
(5.3-7.9 m
2
/l)
Mixing Ratio
1:1 Part 1 to Part 2 by Volume
Induction Period
None
Pot Life @ 70-80°F
2 hours
Dry Heat Resistance
250°F (121°C), color may shift above 150°F (66°C)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Tack-free
30 minutes
Recoat
1-2 hours (After 72 hours, surface must be scarified)
Shelf Life
3 years for Part 2; 2 years for Part 1
Storage Information
PROTECT FROM FREEZING. IF PRODUCT SHOULD FREEZE, ALLOW THE
MATERIAL TO WARM UP AND REMAIN AT NORMAL ROOM TEMPERATURE
FOR 48 HOURS PRIOR TO USE. MIX BY HAND STIRRING.
Safety Information
For additional information, see SDS
Calculated values are shown and may vary slightly from the actual manufactured material.
*Activated material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.