Use and Care Manual

TECHNICAL DATA SPC-66
SPECIALTY
FARM & IMPLEMENT ENAMELS
Form: GDH-959
Rev.: 091817
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Farm & Implement Enamels provide a
durable, rust preventive finish in bright, original equipment
colors. This Stops Rust
®
formula offers excellent coverage,
chip resistance and color retention. Farm & Implement
Enamels are ideal for tractors, farm implements, lawn
mowers, and more. Not for use on galvanized metal.
.PRODUCTS .
SKU Description
Quarts
280104 Gloss Black
280105 Gloss White
280106 Gray Primer
280107 Low Gloss Black
280108 John Deere Green
280109 International Harvester Red
280150 John Deere Yellow
280151 Red Oxide Metal Primer
280152 Massey Ferguson Red
280153 Ford Blue
280154 Ford Gray
280155 Ford Red
280156 Allis Chalmers Orange
280157 Massey Ferguson Gray
280158 New Holland Yellow
280159 Kubota Orange
280160 International Harvester White
280161 New Holland Red
280162 Oliver Green
280163 Caterpillar Yellow
280164 Transport Yellow
Gallons
280165 Gloss Black
280166 Gloss White
280167 International Harvester Red
280168 Low Gloss Black
280169 Gray Primer
280170 John Deere Green
280171 Red Oxide Metal Primer
280172 Ford Blue
280173 Massey Ferguson Red
280174 Massey Ferguson Gray
280175 John Deere Yellow
280176 Allis Chalmers Orange
280177 Ford Red
280178 Ford Gray
280179 Caterpillar Yellow
280180 New Holland Yellow
280181 Transport Yellow
280182 New Holland Red
280183 Kubota Orange
280184 Oliver Green
280185 International Harvester White
. PRODUCT APPLICATION .
SURFACE PREPARATION
ALL SURFACES: Remove all dirt, grease, oil, salt and
chemical contaminants by washing the surface with a
commercial detergent, or other suitable cleaning method.
Mold and mildew must be cleaned with a chlorinated
cleaner or bleach solution. Rinse with fresh water and
allow to thoroughly dry.
STEEL: Scrape and wire brush or power tool clean to
remove loose rust, scale and deteriorated coatings. Use
7769 Rusty Metal Primer for sound rusted or clean metal
before application of a finish coat. 7780 Clean Metal
Primer is best for clean metal but may be used on sound
rusted metal as well.
PREVIOUSLY COATED: Previously coated surfaces must
be sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile. Farm Equipment Enamels are compatible with
most coatings, but a test patch is suggested.
WARNING! If you scrape, sand or remove old paint from
any surface, you may release lead paint dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE;
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by
contacting the National Lead Information Hotline at 1-800-
424-LEAD or log on to www.epa.gov/lead.
APPLICATION
Apply only when air and surface temperatures are
between 50-90°F (10-32°C) and the relative humidity is
below 85% to ensure proper drying. Stir thoroughly before
using. Do not thin with gasoline, lacquer thinner or
turpentine.